ZyXEL Communications 128L Prestige Front Panel, Connecting the Power Adapter to your Prestige

The UTP port is used to connect to a 10Base-T network. 10Base-T networks use Unshielded Twisted Pair (UTP) cable and RJ-45 connectors that look like a bigger telephone plug with 8 pins. Two types of gray Ethernet cables come with the package:

∙Straight through cable (white tag): Connect your Prestige 128L to a 10Base-T hub.

∙Crossover cable (red tag): Connect your Prestige to your computer directly without a hub.

ONOTE: IF THIS CABLE IS USED TO CONNECT IDSL, IT MAY DAMAGE YOUR PRESTIGE.

AUI

The AUI port (the connector with 15 pins) is used to connect your Prestige to a 10Base5 (thicknet) network.

If you have a 10Base2 network using BNC connectors and thin coaxial cables, you will need a transceiver between the AUI port and the 10Base2 cabling.

Connecting the Power Adapter to your

Prestige

Plug the 16VAC 1000mA power adapter into the outlet on the rear panel of the Prestige labeled POWER.

At this point, you should have connected the RS-232 cable, the ISDN phone line, the Ethernet cable, and the power supply. You can now power on your Prestige.

Prestige Front Panel

Names and descriptions of the Prestige front panel LEDs are listed below:

Installation 17