Peavey CS2000H, 12/0280304941 manual To Stereo

9

2 3

1

6

5

4

7

8

10

11

	Mono Bi-Amp Operation (sub woofer & mid/high enclosure)
	Set AMP MODE switch		to STEREO.
1.		1
	Set the channel A AMP FUNCTION switch				to HIGH PASS.
2.				2

3.Turn on the channel A LOW CUT 3 .

4.	Set channel A LOW CUT frequency adjustment knob	4	to match the low frequency cut-off or the -3 dB down point
	of the sub woofer. (If you don’t know this specification‚ set it for 40 Hz.)

5.Set the channel A CROSSOVER frequency adjustment knob 100–150 Hz).

5

to the desired crossover frequency (usually

6. Set the channel B AMP FUNCTION switch 6 to FULL RANGE.

7.Plug a short shielded cable into the high pass/full range output of channel A

8. Connect the other end of the same cable to the channel B input 8 .

9.Connect the Mono program signal to the channel A input 9 .

10.	Connect the sub woofer(s) (in parallel) to the channel A output	10	.
11.	Connect the mid/high enclosure(s) (in parallel) to the channel B output				.
				11

7

.

14