Installation
Installation for Monitor Unit
Installation location and cleaning
Select for installation a location where the stand can be placed
completely horizontal or where the front edge of the support | A | B | C |
|
|
| |
Figure A. |
|
|
|
Do not install in locations where the entire support is at a |
|
|
|
diagonal such as in Figure B or where the monitor unit is |
|
|
|
facing down such as in Figure C. |
|
|
|
2CAUTION
Thoroughly wipe away and dust or grease from the installation location using a cloth which has been soaked in a neutral cleaning agent and wrung out. Attach the stand after allowing the installation location to dry.
1Bend the stand support to conform to the shape of the installation location.
2Adjust the shape of the support so that there is no rattling or gap when the stand is placed on the support.
3Peel off the protective strip from the
2CAUTION
•Do not attach the
•If the temperature of the surface of the installation location is low, warm it up using a heater or other means before attaching the stand. Low temperature may weaken the adhesive strength of the tape.
•The supplied stand is specially intended for this product. Do not use it with another monitor.
4Secure the stand using the supplied tapping screw (Accessory H).
5After attaching the stand, allow it to sit undisturbed for 24 hours.
6Take care not to apply any force to the stand during this time.
7Fully loosen the installation screws, align the slit on the rear of the unit with the installation shoe and slide the monitor unit onto the stand.
8Adjust the height, horizontal angle and vertical angle of the monitor and securely tighten the installation screws.
You can also adjust the monitor unit's forward position by loosening the angle adjustment knobs and adjusting the angle of the monitor unit's installation stand.
Accessory E
Tighten |
Loosen |
Tighten |
Loosen
Accessory H | Protective strip |
Installation surface
10 - English