Kenwood LZ-7500 instruction manual System Setup Screen-2, Touch Panel Adjustment Screen

Operation

System Setup Screen-2

A V - O U T

	N O R M	N A V
	V D 1	V D 2
B E E P
	O N	O F F

Setting the AV Output Mode <AV OUT>

Touch Setting

[7NORMAL] Picture/sound with monitor picture

[7NAV]	Navigation Sound
[7VD1]	Picture/sound from <AV IN-1> terminal
[7VD2]	Picture/sound from <AV IN-2> terminal

		Touch Sensor Tone <BEEP>
S Y S T E M	RTN	Setting the operation check sound (beep sound)
		ON/OFF.
		Touch	Setting
		[7ON]	Touch sensor tone is turned on
		[7OFF]	Touch sensor tone is turned off

Return to the System Setup Screen -1

Touch the [ 2 ] button.

Exit the System Setup Screen

Touch the [RTN] button.

Return to the setup menu screen.

Touch Panel Adjustment Screen

T O U C H P A N E L A D J U S T

P l e a s e T o u c h

t h e C e n t e r o f

t h e B u t t o n i n t h e L e f t - B o t t o m C o r n e r

C A N C E L R E S E T

Touch Panel Adjustment

The touch panel can be adjusted if the position touched and the operation performed do not match.

1Accurately touch the mark at the lower left.

2Accurately touch the mark at the upper right.

When the mark at the upper right is touched, the adjustment is completed and the system setup menu screen reappears.

• If the [ CANCEL ] button is touched without touching the button at the lower left, the adjustment is cancelled and the screen that was set before switching to the system setup menu reappears.

•If the [ CANCEL ] button is touched after touching the button at the lower left, the button at the lower left reappears.

•If the [ RESET ] button is touched, the settings are reset to the factory defaults and the setup menu screen reappears.

6 - English