Installation
Accessories
G
A
D
H
(Ø4 x 12 mm)
B 
E
I
C 
F 
(Ø4 x 16 mm)
The use of any accessories except for those provided might result in damage to the unit. Make sure only to use the accessories shipped with the unit, as shown above.
Installation Procedure
1To prevent short circuits, remove the key from the ignition and disconnect the · terminal of the battery.
2Make the proper input and output cable connections for each unit.
3Connect the wiring harness cables in the following order: ground, ignition.
4Connect the wiring harness connector to the unit.
5Install the unit in your car.
6Reconnect the · terminal of the battery.
2WARNING
•This product is intended for use with 12V DC negative ground power only. Do not connect it to any other power supply
•To prevent shorting, disconnect the battery cable from the negative terminal of the battery during installation.
•Be sure to firmly stabilise this product. Do not install it in a location which is not stable.
•Follow the installation and wiring procedures described in this manual. Improper wiring or modified installation can not only result in malfunction or damage to the unit but may also result in an accident.
•Do not install the unit in the following locations.
•A location which interferes with the operation of the air bag system.
•A location which is not made of plastic.
\Installing on leather, wood or cloth may damage the surface.
•A location subject to direct sunlight, subject to the air from the air conditioner, or subject to moisture or high temperature.
\This may cause deformation of the monitor unit.
•Be sure to use the supplied screws for installation. Using screws longer than those supplied may destroy parts inside the unit causing it to smoke. Using screws shorter than those supplied may cause the unit to come looks from the installation bracket.
•If you are not going to install the unit using the supplied monitor stand, be sure to use a commercially available monitor stand. (Mounting holes for such a stand are located on the bottom of the monitor unit.)
2CAUTION
•If your car's ignition does not come with an ACC position, connect the ignition cables to a power source that can be turned on and off with the ignition key. If you connect the ignition wire to a power source that receives a constant voltage supply, as with battery cables, the battery may die.
•If the fuse blows, first make sure that the cables have not caused a short circuit, then replace the old fuse with one with the same rating.
•Do not let unconnected cables or terminals touch metal on the car or anything else conducting electricity. To prevent short circuits do not remove the caps from unused terminals or from the ends of the unconnected cables.
•After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are working properly.
•Insulate unconnected cables with vinyl tape or other similar material.
•Thoroughly wipe away oil and other dirt from the installation surface. Please avoid installation on uneven surfaces.
8 - English