Elo TouchSystems AMM17TK2, AMM18TK2, AMM170TK2, AMM19TK2 manual Ddc, Installation, Steps

AMM170TK2/AMM17TK2/AMM18TK2/AMM19TK2/AMM19TK2(HB) 17

DDC

To make your installation easier, the monitor is able to Plug and Play with your system if your system also supports DDC protocol. The DDC (Display Data Channel) is a communication protocol through which the monitor automatically informs the host system about its capabilities, for example, supported resolutions and corresponding timing. The monitor supports DDC1 and DDC2B standard.

INSTALLATION

To install the monitor to your host system, please follow the steps as given below:

Steps

1.Use the VGA cable that provides D-SUB 15-pin connector and connect to the 15-pin connector on the VGA controller card.

2.Connect the DC power to the DC power connector on the monitor.

3.Connect one end of AC power cord into the AC Adapter and the other end to AC power outlet.

4.Then turn the computer on and then the monitor.

5.If the monitor still does not function properly, please refer to the troubleshooting section to diagnose the problem.

CONNECTING the POWER CORD

*Check first to make sure that the power cord you use is the correct type required for your area.

*This monitor has an universal AC adapter that allows operation in either AC 100 - 240 Vac voltage area. No user-adjustment is required.

*Plug one end of the power cord to the AC adapter, plug another end to a proper AC outlet.

The cord set should have the appropriate safety approvals for the country in which the equipment will be installed and marked HAR.

For 120 volt Applications, use only UL Listed deachable power cord with NEMA configuration 5-15P type (parallel blades) plug cap. For 240 volt applications use only UL Listed Detachable power supply cord with NEMA configuration 6-15P type (tandem blades) plug cap.