Dukane 9060 Appendix Troubleshooting, Power Indicator, Projector Condition, Status Indicator

10. Appendix

xTroubleshooting

This section helps you resolve problems you may encounter while setting up or using the projector.

Power Indicator

	Indicator Condition			Projector Condition	Note
		Off		The main power is off	–
Blinking light		Green blinking	0.5 sec ON,	The projector is getting ready to turn on.	Wait for a moment.
			0.5 sec OFF
			2.5 sec ON,	Off Timer or Sleep Timer is active.	–
			0.5 sec OFF
		Orange blinking	0.5 sec ON,	The projector is cooling down.	Wait for a moment.
			0.5 sec OFF
			2.5 sec ON,	On Timer is active.	–
			0.5 sec OFF
Steady light		Green		The projector is turned on.	–
		Orange		The projector is in Standby or Idle.	–
Status Indicator
	Indicator Condition			Projector Condition	Note
		Off		Normal	–
Blinking light		Red blinking	1 cycle (0.5 sec ON,	Lens hood or lamp cover error	Replace the lens hood or the lamp cover
			2.5 sec OFF)		correctly.
			2 cycle (0.5 sec ON,	Temperature error	The projector is overheated. Move the
			0.5 sec OFF)		projector to a cooler location.
			3 cycle (0.5 sec ON,	Power error	Power unit will not work correctly.
			0.5 sec OFF)
			4 cycle (0.5 sec ON,	Fan error	Cooling fan has stopped. Contact your
			0.5 sec OFF)		dealer.
Steady light		Red (GT6000 only)		Circuit error	An error occurs in the circuit. Consult
					your dealer.
		Orange		Control key locked	You have pressed control panel key when
					Control Key Lock is enabled.
		Green		Idle condition	–
Lamp 1/2 Indicator
	Indicator Condition			Projector Condition	Note
		Off		Light off	–
Blinking light		Red blinking	2.5 sec ON,	Lamp has reached its end of life. Lamp	Replace the lamp.
			0.5 sec OFF	replacement message will be displayed.
			1 cycle (0.5 sec ON,	No lamp	Lamp is not installed. Turn off the power
			2.5 sec OFF)		and install lamp.
			6 cycle (0.5 sec ON,	Lamp error	Lamp fails to light. Wait a full minute and
			0.5 sec OFF)		turn on the power again. If this will not
					solve the problem, consult your dealer.
			7 cycle (0.5 sec ON,	Lamp data error	Fails to read lamp data.
			0.5 sec OFF)		Consult your dealer.
		Green blinking		Re-firing the lamp	Wait for a moment.
		Orange blinking		Switching from Lamp 1 to 2	Wait for a moment.
Steady light		Red		Lamp has been used beyond its limit. The	Replace the lamp.
				projector will not turn on until the lamp
				is replaced.
		Green		Lamp mode is set to Normal mode	–
		Orange		Lamp mode is set to Eco mode.	–

10-3