9. Maintenance
x Replacing or Cleaning the Filter
To replace the filter:
•Replace both filters at the same time.
•Before replacing the filters, remove dust and dirt from the pro- jector cabinet.
•The projector contains
•Do not wash the filter with water. Water will damage the filter membrane.
•Reattach the filter cover correctly. Failure to do so may cause projector malfunction.
Preparation: Replace the lamp before replacing the filters.
1. Pull out the filter cover by pushing up on the catch.
(This must be done to the filters on both left and right.)
1 | 2 |
|
Filter holding frame | Filter cover | Filter |
2.Replace both filters.
1. Remove the filter and clean the filter cover.
1
2
2. Place the new filter on the filter cover in the correct direction.
3.Reinstall the filter cover. (This must be done to both left and right)
4.Plug the power cable into a wall outlet and turn on the projector.
5.Reset the filter usage hours to zero.
Select [Menu] → [Projector Options] → [Setup] → [Page 5] → [Clear Filter Usage Meter] → [OK]. Press the ENTER button.
The
CAUTION
•Turn off the power, wait for 90 seconds (2 minutes in the optional ex- tended life lamp GT60LPS), turn off the main power and unplug the projector before replacing the filter.
•Do not attempt to operate the projector without filter.
•Your projector will not operate unless the filter cover is installed cor- rectly.
To clean the filter:
Pull out the filter by pushing up on the catch. Vacuum the filter- through the filter.
The "Please clean the filters" message will be displayed each time the projector is turned on after it has been used in excess of 168 hours. Should this message appear, clean the filters.
NOTE:
*The message can be turned on or off using the "Message" option on the Setup menu. See page
*After cleaning the filters and resetting the filter usage time back to zero, the mes- sage will not be displayed.
See page