COMPUTER INPUT
PC ADJUSTMENT
AUTO PC ADJUSTMENT
The Auto PC Adjustment function automatically adjusts Fine sync, Total dots, Horizontal and Vertical picture position to conform to your computer. The Auto PC Adjustment function can be operated as follows.
| Auto PC Adj. |
|
1 | Press the MENU button and the | |
appear. Press the POINT LEFT/RIGHT button to move the red | ||
| frame pointer to the PC ADJUST Menu icon. | |
2 | Press the POINT DOWN button to move the red frame pointer to | |
the AUTO PC Adj. icon and then press the SET button twice. |
This Auto PC Adjustment can also be executed by pressing the AUTO PC ADJ. button on the Remote Control Unit.
Store adjustment parameters.
Adjustment parameters from Auto PC Adjustment can be memorized in this projector. Once parameters are memorized, setting can be done just by selecting Mode in the PC SYSTEM Menu (P23). Refer to step 3 of the “MANUAL PC ADJUSTMENT” section (P27).
PC ADJUST MENU
PC ADJUST Menu icon
Move the pointer to the AUTO PC Adj. icon and press the SET button.
NOTE
●The PC ADJUST Menu cannot be operated when the input signal is digital or RGB is selected in the PC SYSTEM Menu (P23).
●Fine sync, Total dots, Horizontal, and Vertical of some computers cannot be fully adjusted with this Auto PC Adjustment function. When the image is not provided properly through this function, manual adjustments are required. (Refer to page 26, 27.)
●The Auto PC Adjustment function cannot be operated when “720p (HDTV),” “1035i (HDTV),” or “1080i (HDTV)” is selected in the PC SYSTEM Menu (P23).
25