Canon LV-5200 Remote Control Unit, Does not work, Wireless Mouse, Function does not, Work

APPENDIX

Problem:	Try these Solutions
Remote Control Unit	● Check the batteries.
does not work.	● Check ALL-OFF switch on the Remote Control Unit is set to “ON.”
	● Make sure nothing is between the Infrared Remote Receiver and the Remote Control
	Unit.
	● Make sure you are not too far from the projector when using the Remote Control Unit.
	Maximum operating range is 16.4’ (5m).
	● Make sure the code of the Remote Control Unit is set to conform to the projector.
	(See the “SETTING” section on page 37.)
Wireless Mouse	● Check the cable connection between the projector and your computer.
function does not	● Check the mouse setting on your computer.
	● Turn the projector on before turning on your computer.
work.

WARNING :

High voltages are used to operate this projector. Do not attempt to open the cabinet.

If the problem still persists after following all operating instructions, contact the sales dealer where you purchased the projector or the service center. Give the model number and explain the problem in detail. We will advise you how to obtain service.

This symbol on the nameplate means the product is Listed by Underwriters Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety standards against risk of fire, casualty and electrical hazards.

The CE Mark is a Directive conformity mark of the European Community. (EC)

43