7. Press the ENTER button.
Screen
8. Use the SELECT | button to select another icon which points |
in the direction. |
|
3.Press the 3D REFORM button on the remote control. The Cornerstone adjustment screen is displayed.
The Cornerstone adjustment screen will disappear when you move the USB mouse cursor.
4.Point to one of the remaining 3 corners and
Screen
Screen
On the Cornerstone adjustment screen, select “Exit” and then “OK”, or press the CANCEL but- ton on the remote control.
The confirmation screen is displayed.
9. Press the SELECT or button to highlight the [OK] and press the ENTER button.
This completes the keystone correction.
Selecting “Cancel” will return to the adjustment screen without saving changes (Step 3).
Selecting "Reset" will return to the factory default. Selecting "Undo" will exit without saving changes.
When using the USB connected to the projector
Preparation: Connect the USB mouse to the projector. See page
1.Project an image so that the screen is smaller than the area of the raster.
2.Pick up any one of the corners and align the corner of the screen with the one of the image. (The drawing shows the upper right cor- ner.)
Projected image
Screen
5.Do the above step 4 for the other two corners so that the projected area becomes smaller than the screen.
Screen
6.To complete the procedure,
7.
This completes the Cornerstone adjustment.
*To return the Cornerstone adjustment to the default settings, left- click on "Reset" in Step 7.
You can save your Cornerstone changes. The changes are saved when you turn off the projector. To do so, select [Projector Options] → [Setup]
→[Page 4]. Select the 3D Reform Save check box. This is not selected at the time of shipment.
*There are limitations of shapes which can be corrected using the Cor- nerstone adjustment.
When adjusting the Cornerstone beyond these limits, you will get the message "Out of adjustment range!" and no correction can be done. Should this happen, do the Cornerstone adjustment again within the allowable range.
*Due to limitations of accuracy within internal processes, there may be some discrepancy of positions between the mouse cursor and corrected shape or one corner and the other 3 corners.
NOTE: To return the 3D Reform correction setting values to the factory default, press and hold the 3D REFORM button for a minimum of 2 seconds.