Auto 3D Reform
Auto 3D Reform automatically corrects distortion by sensing the outline or outer frame of your screen with the projector’s
NOTE:
•The Auto 3D Reform feature supports screen sizes between 30” and 200”.
•If the screen has the same brightness as its background, the
Should this happen, the Auto 3D Reform feature cannot function.
If irregular colors, flaw or change of color are seen on the screen, the
•If there is an object between the
•The Auto 3D Reform feature does not support reflective screens. Matt type or beads type screens are recommended.
Executing the Auto 3D Reform feature
1.Project an image.
See the user’s manual or the quick connect guide for projecting an image.
2.Press the 3D REFORM button.
The 3D Reform (Cornerstone) screen is displayed.
Projected area
3.Press and hold the AUTO ADJUST button for a minimum of 2 sec- onds.
A guide pattern that shows available area for Auto 3D Reform is dis-
played.
*The AUTO ADJ. button on the remote control can also be used for this purpose.
4.Place the projector adjusting its orientation and the angle so that the outline (outer frame) of the screen can be positioned within the gray area of the projected guide pattern.
Screen’s outer frame
5.Highlight [Start] and press the ENTER button.
The Auto 3D Reform feature has been executed. Processing takes about 20 seconds
* To cancel, use the SELECT or button to highlight [Cancel] and press the ENTER button.
NOTE:
*When “4:3 Fill" is selected in “Aspect”, the Auto 3D Reform feature is not available.
*If the screen’s outer frame is larger than gray area of the guide pattern as shown, the Auto 3D Reform feature does not function.
*In the Auto 3D Reform mode, when controlling the projector using PC con- trol, you might not be able to make correction. (The projector can be oper- ated with Dynamic Image Utility 2.0, Image Express Utility 1.0 and HTTP Server function.)
Not recommended