CONNECTING PROJECTOR
TERMINALS OF PROJECTOR
This projector has input and output terminals on its back for connecting computers and video equipment. Refer to the figures on pages
COMPUTER AUDIO INPUT 1/ AUDIO MONITOR OUTPUT JACK
This terminal is switchable and can be used as Computer Audio Input 1 or Audio Monitor Output (variable).
Set up the terminal as either Computer Audio Input 1 or Audio Monitor Output properly before using this terminal.
(See pages 13, 24.)
Note: This terminal does not output audio from INPUT 3.
COMPUTER INPUT/MONITOR OUTPUT TERMINAL (ANALOG)
This terminal is switchable and can be used as Computer Input or Monitor Output. Set up the terminal as either Computer Input or Monitor Output properly before using this terminal.
(See pages
Note: This terminal outputs from the 5 BNC type computer input on INPUT 2 jacks only.
COMPUTER INPUT TERMINAL (DIGITAL)
Connect a computer output (Digital
The HD (HDCP Compatible) signal can also be connected. (See page 13.)
COMPUTER AUDIO
INPUT 2 JACK
Connect an audio output (stereo) from a computer to this jack. (See page 13.)
USB CONNECTOR (Series B)
When controlling a computer with the remote control unit of this projector, connect USB terminal of your personal computer to this terminal. (See page 13.)
RESET BUTTON
This projector uses a micro processor to control the unit, and only occasionally, this micro processor may malfunction and need to be reset. This can be done by pressing the RESET button with a pen, which will shut down and restart the unit. Do not use
INPUT 1
RGB ANALOG IN/OUT | RGB DIGITAL |
|
| ||
|
|
|
|
| R/C |
AUDIO 1 |
| RESET |
| CONTROL PORT | |
IN/OUT |
| AUDIO 2 |
|
| |
G | B | R | H/V |
| V |
VIDEO/Y | Cb/Pb | Cr/Pr |
|
|
|
|
| INPUT 2 |
|
|
|
VIDEO/Y Cb/Pb Cr/Pr | |||||
| |||||
|
|
| ( |
| ) |
|
| INPUT 3 |
|
|
|
R/C JACK
When using the Wired/ Wireless remote control unit as wired, connect the Wired remote control unit to this jack with an Audio cable (Mini Plug [stereo]; not supplied).
CONTROL PORT CONNECTOR
When controlling a computer with the remote control unit of this projector, connect the mouse port of your personal computer to this connector. (See page 13.)
the RESET function excessively.
5 BNC INPUT JACKS
Connect component video output (Y, Cb, Cr or Y, Pb, Pr) from video equipment to VIDEO/Y, Cb/Pb, and Cr/Pr jacks or connect computer output {5 BNC Type (Green, Blue, Red, Horiz. Sync, and Vert. Sync.)} from computer to G, B, R, H/V, and V jacks. (See pages
VIDEO INPUT JACKS | AUDIO INPUT JACKS | |
Connect composite video | Connect an audio output | Connect |
output from video equipment | from video equipment to | from video equipment to |
to VIDEO/Y jack or connect | these jacks. (See page 14.) | this jack. (See page 14.) |
component video outputs to |
|
|
VIDEO/Y, Cb/Pb, and Cr/Pr |
|
|
jacks. (See page 14.) |
|
|
12