Compaq HB1004 manual 4Setup and Configuration

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

3-4Setup and Configuration

To start the Compaq HB1004 System

Configuration Program from

Windows:

1.Insert the Compaq HB1004 Configuration Program diskette into the floppy disk drive

2.In File Manager or Program Manager, click File, then click Run

3.Type A:\HB1004CP for Drive A or B:\HB1004CP for Drive B in the Command Line box

4.Click the OK button to open the program and display the communication dialog box shown in Figure 3-3.

NOTE: The Compaq HB1004 System Configuration Program allows selection of COM Ports 1, 2, 3 or 4 and assumes the normal default IRQ for the appropriate port (i.e. COM1 is IRQ4, COM2 is IRQ3, COM3 is IRQ4 and COM4 is IRQ3). If your communication port is configured differently, it is necessary to specify the correct IRQ for that port. If this is the case, type:

A:\HB1004CP /i[irq#] or B:\HB1004CP /i[irq#]

In the Command Line box.

To start the Compaq HB1004 System

Configuration Program from

Windows 95 or Windows 98:

1.Insert the Compaq HB1004 Configuration Program diskette into the floppy disk drive

2.Click the Start button in the lower left corner of the screen

3.Click Run...

4.Type A:\HB1004CP for Drive A or B:\HB1004CP for Drive B in the Open box

5.Click the OK button to open the program and display the communication dialog box shown in Figure 3-3.