Compaq 380 manual Host Serial Port, USB Port, Auxiliary Serial Port, Power Input

Page 15

Section 1. Features and Specifications

RAM Space: 40 K bytes

ROM Space: ROM Flash:

Main Program Memory: 512 K Bytes

Boot Loader Memory: 24 K Bytes

Configuration Memory: 8 K Bytes

Host Serial Port

The RS-232 Host Serial Port provides serial communications between the Reader/Encoder and the Host Computer. In addition, the Host Serial Port carries DC power from the remote power pack to the Reader/Encoder. The Host Serial Port is capable of communication speeds of up to 115 K bits/sec.

USB Port

The Host USB 1.1 Port provides communications between the Reader/Encoder and the Host Computer. The USB Cable, 5-pin mini B Plug, connects to host 4-pin USB Type A Plug, with 10-pin RJ45 and 12V/Ground connector for Power Supply.

Auxiliary Serial Port

The Auxiliary Serial Port provides serial communications and power between the Reader/Encoder and an external device. The Auxiliary Serial Port is capable of communication speeds of up to 19.2 Kbits/sec. The port is also capable of carrying +12 VDC at up to 1 A for a device connected to this port.

Power Input

The Reader/Encoder is powered by a 12 VDC power-pack. The +12 VDC power is carried to the Reader/Encoder as part of the Host Serial cable.

All other voltages required by the Main PCB are generated onboard as required.

The input connector and cabling carry power to support the Reader/Encoder.

Polarization and Securement of Serial Port Cables

The ports, located at the rear of the Reader/Encoder, use RJ connectors with locking tabs, which assist in securing the cable to the Reader/Encoder.

7

Image 15
Contents August Registered to ISO Manual Part NumberRevisions TERMS, Conditions and Restrictions Software License AgreementFCC Warning Statement FCC Compliance Statement Table of Contents Operation and Maintenance Vii IntelliStripe Features ConfigurationsMagTek Documents Software AccessoriesApplicable Documents StandardsFront Opto-Sensor Card-Landed Mechanical Switch SensorMotorized Card Transport Lead-in Roller SystemMagstripe Read/Encode Spring-Loaded Card Registration GuidesAbility To Transport 0.010 to 0.035 Cards Card Entry/OrientationSmartCard Packing/EnclosureSmall Footprint Electronics and PCBs Auxiliary Serial Port Power InputHost Serial Port USB PortRotary Pulse Generator ISO-8 Smartcard Connector with Landing SwitchMicrocontroller LED Indicator Opto-Sensor InputsFirmware External Auto-Ranging Power PackSpecifications SpecificationsMounting Rear Panel and Cable Connections Dimensions for Mounting Holes for 3-Screw Set and Foot PadsRear Panel and Cover Cable Connections RS-232 Cable Connections USB Cable Connections USB Signal Rear Panel Cover Replaced RS-232 Connection Rear Panel Cover Replaced USB Connection IntelliStripe Ejector Rod for Card Jams Preventive MaintenanceCorrective Maintenance OperationEjector Rod Removal from Storage Appendix A. Dimensions for Mounting Figure A-1. Mounting Dimensions Figure A-2. Mounting Dimensions Figure A-3. MagTek Mounting Plate, I380 Figure A-4. MagTek Mounting Plate, I380 Appendix A. Dimensions for Mounting