Compaq 380 manual Appendix A. Dimensions for Mounting

Page 29

APPENDIX A. DIMENSIONS FOR MOUNTING

MOUNTING

The bottom of the unit is shown in Figure 2-1 and 2-2. The IntelliStripe 380 may be mounted in one of three ways: 1) foot pads, 2) set of mounting holes for 3 screws (4 x 40), and 3) 4 lock-in- place slots.

The mounting dimensions of the 3 screw holes and the 4 lock-in-place slots are shown in Figure A-1.

Footpad Mounting

The footpads are mounted at the factory if it is the default. Simply place the unit on a level surface with approximately 4 inches clearance from obstructions at the front of the unit for card clearance. Leave enough room at the rear of the unit for cable clearance.

Mounting Hole Screws

Locate the 3 screw holes (4 x 40 screws) shown in Figure 2-1. The length of the screws depends on the thickness of the mounting surface. Drill 3 holes in the mounting surface that match the set of screw holes. The screws are mounted from under the mounting surface and into the bottom of the IntelliStripe 380.

Lock-in-place-slots

The overall dimensions of the unit are shown in Figure A-2.

The MagTek Mounting Plate, Figures A-3 and A-4, show the use of the Lock-in-place slots (Refer also to Figures 2-2). In the example the holes are placed over mounted inserts and the unit is pulled the length of the slots forcing the thickest part of the plate to lock the unit in place. The value and tolerances of the plate at the end of the slots are .087” ±.005” (Figure A1), and the value and tolerances of the “stem” of the mushroom-shaped inserts are .085” ±.005” as shown in Figure A-4.

Flange

The flange shown in Figure 2-2 may be used to screw the unit to the mounting surface using a #4 screw. It can be used with any mounting configuration.

21

Image 29
Contents August Registered to ISO Manual Part NumberRevisions TERMS, Conditions and Restrictions Software License AgreementFCC Warning Statement FCC Compliance Statement Table of Contents Operation and Maintenance Vii IntelliStripe Features ConfigurationsApplicable Documents Software AccessoriesStandards MagTek DocumentsMotorized Card Transport Card-Landed Mechanical Switch SensorLead-in Roller System Front Opto-SensorAbility To Transport 0.010 to 0.035 Cards Spring-Loaded Card Registration GuidesCard Entry/Orientation Magstripe Read/EncodeSmall Footprint SmartCardPacking/Enclosure Electronics and PCBs Host Serial Port Power InputUSB Port Auxiliary Serial PortMicrocontroller LED Indicator ISO-8 Smartcard Connector with Landing SwitchOpto-Sensor Inputs Rotary Pulse GeneratorFirmware External Auto-Ranging Power PackSpecifications SpecificationsMounting Rear Panel and Cable Connections Dimensions for Mounting Holes for 3-Screw Set and Foot PadsRear Panel and Cover Cable Connections RS-232 Cable Connections USB Cable Connections USB Signal Rear Panel Cover Replaced RS-232 Connection Rear Panel Cover Replaced USB Connection IntelliStripe Corrective Maintenance Preventive MaintenanceOperation Ejector Rod for Card JamsEjector Rod Removal from Storage Appendix A. Dimensions for Mounting Figure A-1. Mounting Dimensions Figure A-2. Mounting Dimensions Figure A-3. MagTek Mounting Plate, I380 Figure A-4. MagTek Mounting Plate, I380 Appendix A. Dimensions for Mounting