Compaq 380 manual Rear Panel Cover Replaced RS-232 Connection

Page 24

IntelliStripe 380

Table 2-3. Cable Connections – USB Power

P3 – 2.5 mm Power Jack

Wire Color

P4 – 10P10C RJ Plug

Shell

Gnd

Drain Wire

1

PWR GND

Center Pin

+12

26AWG Wire (Black)

2

+12

Shell

Gnd

Braid Shield

6

PWR GND

Center Pin

+12

26AWG Wire (Brown)

8

+12

Center Pin

+12

26AWG Wire (Red)

10

+12

Check all connectors to ensure they are properly connected. Replace the Rear Panel Cover by inserting the mounting clips into the guide slots and press into the attachment slots as indicated in Figure 2-3.

After connectors are checked and the Rear Panel Cover replaced, the unit should look similar to Figure 2-6 and 2-7.

Ejector Rod Hole

For Card Removal

Rear Panel Cover

Cable To Peripheral

P/N 16051415

Cable To PC

P/N 16051417

Figure 2-6. Rear Panel Cover Replaced – RS-232 Connection

16

Image 24
Contents Manual Part Number August Registered to ISORevisions Software License Agreement TERMS, Conditions and RestrictionsFCC Warning Statement FCC Compliance Statement Table of Contents Operation and Maintenance Vii IntelliStripe Configurations FeaturesSoftware Accessories Applicable DocumentsStandards MagTek DocumentsCard-Landed Mechanical Switch Sensor Motorized Card TransportLead-in Roller System Front Opto-SensorSpring-Loaded Card Registration Guides Ability To Transport 0.010 to 0.035 CardsCard Entry/Orientation Magstripe Read/EncodeSmartCard Packing/EnclosureSmall Footprint Electronics and PCBs Power Input Host Serial PortUSB Port Auxiliary Serial PortISO-8 Smartcard Connector with Landing Switch Microcontroller LED IndicatorOpto-Sensor Inputs Rotary Pulse GeneratorExternal Auto-Ranging Power Pack FirmwareSpecifications SpecificationsMounting Dimensions for Mounting Holes for 3-Screw Set and Foot Pads Rear Panel and Cable ConnectionsRear Panel and Cover Cable Connections RS-232 Cable Connections USB Cable Connections USB Signal Rear Panel Cover Replaced RS-232 Connection Rear Panel Cover Replaced USB Connection IntelliStripe Preventive Maintenance Corrective MaintenanceOperation Ejector Rod for Card JamsEjector Rod Removal from Storage Appendix A. Dimensions for Mounting Figure A-1. Mounting Dimensions Figure A-2. Mounting Dimensions Figure A-3. MagTek Mounting Plate, I380 Figure A-4. MagTek Mounting Plate, I380 Appendix A. Dimensions for Mounting