Compaq 380 Opto-Sensor Inputs, Rotary Pulse Generator, External SAM Ranch Interface, Optional

Page 16

IntelliStripe 380

Opto-Sensor Inputs

The Main PCB provides inputs for the three opto-sensors (Front, Encode, and Rear).

Rotary Pulse Generator

The Main PCB provides input for the MagTek 75/210 bpi Rotary Pulse Generator (RPG).

External SAM Ranch Interface, Optional

The Main PCB provides resources for interconnect, securement, and power of an optional SAM Ranch PCB. The optional SAM Ranch PCB is accessed from the hatch door at the bottom of the Encoder/Reader.

Dual Color LED

The Main PCB provides facilities for a dual color, red/green PCB. The LED is located on the front bezel of the Encoder/Reader. When the unit is powered up, the LED will blink green or red until the Host commands it to a different state. Green means the unit is ready for normal operation. Red means a card is jammed in the unit and should be manually removed.

ISO-8 Smartcard Connector with Landing Switch

The Main PCB provides resources to support an interface with an ISO-8 smartcard connector with its associated landing switch. The electronics meet EMV Level 1 requirements.

3-Track Read/Encode Magnetic Head

The Main PCB supports an interface to a 3-Track Read/Encode Magnetic Head. A flex-cable circuit connects the magnetic head to the Main PCB.

DC Motor

The Main PCB supports a bidirectional drive interface to a DC motor. The motor drives the card in the forward and reverse directions in the transport. The motor can also be driven with a small “holding” current to keep a card positioned over the Smart Card contact block during a Smart Card session.

Microcontroller LED Indicator

The Main PCB supports a “watchdog” LED, which blinks on and off providing visual indication that the microcontroller is in a normal state of operation. The LED can be viewed when the bottom access hatch is removed from the enclosure.

8

Image 16
Contents Manual Part Number August Registered to ISORevisions Software License Agreement TERMS, Conditions and RestrictionsFCC Warning Statement FCC Compliance Statement Table of Contents Operation and Maintenance Vii IntelliStripe Configurations FeaturesSoftware Accessories Applicable DocumentsStandards MagTek DocumentsCard-Landed Mechanical Switch Sensor Motorized Card TransportLead-in Roller System Front Opto-SensorSpring-Loaded Card Registration Guides Ability To Transport 0.010 to 0.035 CardsCard Entry/Orientation Magstripe Read/EncodePacking/Enclosure SmartCardSmall Footprint Electronics and PCBs Power Input Host Serial PortUSB Port Auxiliary Serial PortISO-8 Smartcard Connector with Landing Switch Microcontroller LED IndicatorOpto-Sensor Inputs Rotary Pulse GeneratorExternal Auto-Ranging Power Pack FirmwareSpecifications SpecificationsMounting Dimensions for Mounting Holes for 3-Screw Set and Foot Pads Rear Panel and Cable ConnectionsRear Panel and Cover Cable Connections RS-232 Cable Connections USB Cable Connections USB Signal Rear Panel Cover Replaced RS-232 Connection Rear Panel Cover Replaced USB Connection IntelliStripe Preventive Maintenance Corrective MaintenanceOperation Ejector Rod for Card JamsEjector Rod Removal from Storage Appendix A. Dimensions for Mounting Figure A-1. Mounting Dimensions Figure A-2. Mounting Dimensions Figure A-3. MagTek Mounting Plate, I380 Figure A-4. MagTek Mounting Plate, I380 Appendix A. Dimensions for Mounting