Compaq 380 manual FCC Warning Statement FCC Compliance Statement

Page 4

FCC WARNING STATEMENT

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

FCC COMPLIANCE STATEMENT

This device complies with Part 15 Of The FCC Rules. Operation of this device is subject to the following two conditions: (1) This device may not cause harmful interference. And (2) This device must accept any interference received, including interference that may cause undesired operation.

CANADIAN DOC STATEMENT

This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de las classe A prescrites dans le Réglement sur le brouillage radioélectrique édicté par les ministère des Communications du Canada.

UL/CSA

This product is recognized per Underwriter Laboratories and Canadian Underwriter Laboratories 1950.

iv

Image 4
Contents Manual Part Number August Registered to ISORevisions Software License Agreement TERMS, Conditions and RestrictionsFCC Warning Statement FCC Compliance Statement Table of Contents Operation and Maintenance Vii IntelliStripe Configurations FeaturesSoftware Accessories Applicable DocumentsStandards MagTek DocumentsCard-Landed Mechanical Switch Sensor Motorized Card TransportLead-in Roller System Front Opto-SensorSpring-Loaded Card Registration Guides Ability To Transport 0.010 to 0.035 CardsCard Entry/Orientation Magstripe Read/EncodePacking/Enclosure SmartCardSmall Footprint Electronics and PCBs Power Input Host Serial PortUSB Port Auxiliary Serial PortISO-8 Smartcard Connector with Landing Switch Microcontroller LED IndicatorOpto-Sensor Inputs Rotary Pulse GeneratorExternal Auto-Ranging Power Pack FirmwareSpecifications SpecificationsMounting Dimensions for Mounting Holes for 3-Screw Set and Foot Pads Rear Panel and Cable ConnectionsRear Panel and Cover Cable Connections RS-232 Cable Connections USB Cable Connections USB Signal Rear Panel Cover Replaced RS-232 Connection Rear Panel Cover Replaced USB Connection IntelliStripe Preventive Maintenance Corrective MaintenanceOperation Ejector Rod for Card JamsEjector Rod Removal from Storage Appendix A. Dimensions for Mounting Figure A-1. Mounting Dimensions Figure A-2. Mounting Dimensions Figure A-3. MagTek Mounting Plate, I380 Figure A-4. MagTek Mounting Plate, I380 Appendix A. Dimensions for Mounting