Compaq 380 manual Mounting

Page 19

SECTION 2. INSTALLATION

The installation of the IntelliStripe 380 Reader-Encoder consists of mounting the unit on a flat surface, connecting the I/O RS-232 cable to the host serial port, the Auxiliary cable to a peripheral device, and the Power Supply to the I/O cable and to a wall receptacle.

MOUNTING

The bottom of the unit is shown in Figure 2-1 and 2-2. The IntelliStripe 380 may be mounted in one of three ways: 1) foot pads, 2) set of mounting holes for 3 screws (4 x 40), and 3) 4 lock-in- place slots.

Footpad Mounting

The footpads are mounted at the factory if it is the default. Simply place the unit on a level surface with approximately 4 inches clearance from obstructions at the front of the unit for card clearance. Leave enough room at the rear of the unit for cable clearance.

Mounting Hole Screws

Locate the 3 screw holes (4 x 40 screws) shown in Figure 2-1. The length of the screws depends on the thickness of the mounting surface. Drill 3 holes in the mounting surface that match the set of screw holes. The screws are mounted from under the mounting surface and into the bottom of the IntelliStripe 380.

Lock-in-place-slots

Figure 2-2 shows the dimensions of the Lock-in-place slots, to be used with optional Baseplate Mounting, P/N 16054403. (See Appendix A, Figure A-4.) The holes next to the lock-in-place- slots are for inserts. The holes are placed over mounted inserts and the unit is pulled the length of the slots forcing the thickness of the bottom plate to lock the unit in place. Dimensions of the slots and inserts are shown in Appendix A.

Flange

The flange shown in the illustration may be used to screw the unit to the mounting surface using a #4 screw. It can be used with any mounting configuration.

MagTek Mounting Plate

MagTek offers an optional mounting plate. The plate dimensions are shown in Appendix A, Figure A-4.

11

Image 19
Contents August Registered to ISO Manual Part NumberRevisions TERMS, Conditions and Restrictions Software License AgreementFCC Warning Statement FCC Compliance Statement Table of Contents Operation and Maintenance Vii IntelliStripe Features ConfigurationsMagTek Documents Software AccessoriesApplicable Documents StandardsFront Opto-Sensor Card-Landed Mechanical Switch SensorMotorized Card Transport Lead-in Roller SystemMagstripe Read/Encode Spring-Loaded Card Registration GuidesAbility To Transport 0.010 to 0.035 Cards Card Entry/OrientationPacking/Enclosure SmartCardSmall Footprint Electronics and PCBs Auxiliary Serial Port Power InputHost Serial Port USB PortRotary Pulse Generator ISO-8 Smartcard Connector with Landing SwitchMicrocontroller LED Indicator Opto-Sensor InputsFirmware External Auto-Ranging Power PackSpecifications SpecificationsMounting Rear Panel and Cable Connections Dimensions for Mounting Holes for 3-Screw Set and Foot PadsRear Panel and Cover Cable Connections RS-232 Cable Connections USB Cable Connections USB Signal Rear Panel Cover Replaced RS-232 Connection Rear Panel Cover Replaced USB Connection IntelliStripe Ejector Rod for Card Jams Preventive MaintenanceCorrective Maintenance OperationEjector Rod Removal from Storage Appendix A. Dimensions for Mounting Figure A-1. Mounting Dimensions Figure A-2. Mounting Dimensions Figure A-3. MagTek Mounting Plate, I380 Figure A-4. MagTek Mounting Plate, I380 Appendix A. Dimensions for Mounting