Compaq 380 manual External Auto-Ranging Power Pack, Firmware

Page 17

Section 1. Features and Specifications

External Auto-Ranging Power Pack

The Reader/Encoder is powered from an external power-pack, which is located near the Host Computer System. Power is routed to the Reader/Encoder through the Host RS-232 cable.

Auto-Ranging Input

The external power pack features an Auto-ranging AC input that allows for direct connection to either a 100 VAC or 220 VAC, 50 to 60 Hz.

Output Rating

The power pack is rated at approximately +12 VDC @ 4 A ± 5%.

Firmware

The firmware for the Reader/Encoder is based upon existing MCP protocol and command set.

Memory Cards

The firmware supports smartcard interfaces to memory cards.

FLASH Download Protection

To prevent illegal applications from being downloaded into the Reader/Encoder, the firmware verifies that the downloaded FLASH program is provided (authorized) by MagTek. If the program cannot ID itself correctly, the boot loader program abandons the FLASH load sequence and returns a unique status code that identifies the situation to the Host.

9

Image 17

Contents August Registered to ISO Manual Part NumberRevisions TERMS, Conditions and Restrictions Software License AgreementFCC Warning Statement FCC Compliance Statement Table of Contents Operation and Maintenance Vii IntelliStripe Features ConfigurationsApplicable Documents Software AccessoriesStandards MagTek DocumentsMotorized Card Transport Card-Landed Mechanical Switch SensorLead-in Roller System Front Opto-SensorAbility To Transport 0.010 to 0.035 Cards Spring-Loaded Card Registration GuidesCard Entry/Orientation Magstripe Read/EncodeSmall Footprint SmartCardPacking/Enclosure Electronics and PCBs Host Serial Port Power InputUSB Port Auxiliary Serial PortMicrocontroller LED Indicator ISO-8 Smartcard Connector with Landing SwitchOpto-Sensor Inputs Rotary Pulse GeneratorFirmware External Auto-Ranging Power PackSpecifications SpecificationsMounting Rear Panel and Cable Connections Dimensions for Mounting Holes for 3-Screw Set and Foot PadsRear Panel and Cover Cable Connections RS-232 Cable Connections USB Cable Connections USB Signal Rear Panel Cover Replaced RS-232 Connection Rear Panel Cover Replaced USB Connection IntelliStripe Corrective Maintenance Preventive MaintenanceOperation Ejector Rod for Card JamsEjector Rod Removal from Storage Appendix A. Dimensions for Mounting Figure A-1. Mounting Dimensions Figure A-2. Mounting Dimensions Figure A-3. MagTek Mounting Plate, I380 Figure A-4. MagTek Mounting Plate, I380 Appendix A. Dimensions for Mounting