Selecting Computer Mode

COMPUTER MODE

Direct Operation

Select Computer mode by pressing the MODE button on the Top Control or the Remote Control Unit.

Computer

Video

Menu Operation

Press the MENU button and the ON-SCREEN MENU will appear.

Press the POINT LEFT/RIGHT buttons to select Computer and press the SELECT button.

CURRENT MODE DISPLAY

When selecting the Computer Mode, the Current Mode display appears. It shows the information of the computer of the mode selected.

Providing the information of the computer detected by the projector.

SELECTING COMPUTER SYSTEM

Automatic Multiscanning system

This projector automatically tunes to most different types of computer based on VGA, SVGA, XGA or SXGA (refer to "COMPATIBLE COMPUTER SPECIFICATION" on page 26). When selecting Computer, this projector becomes automatically suited to the incoming signal and projects the proper image without any special setting. (Setting of the Computer System may be required when connecting some computers.)

Note : The projector may provides the messages below.

Go PC adj. The projector cannot discriminate or detect the input signal from the computer. Adjust and set the computer system manually. (Refer to page 25.)

No signal There is no signal input from the computer. Make sure the connection of the computer and the projector is set

correctly. (Refer to TROUBLESHOOTING on page 36.)

SYSTEM BOX

Displays the SYSTEM being selected.

Selecting Computer System Manually

To set the Computer system manually, select the mode on the ON-

SCREEN MENU.

1	Press the MENU button and the ON-SCREEN MENU will appear.
1	Press the POINT LEFT/RIGHT buttons to select SYSTEM and
	press the SELECT button. Another dialog box COMPUTER
	MODE Menu will appear.
2	Press the POINT DOWN button and a red-arrow icon will appear.
2	Move the arrow to the system that you want to set, and then press

SELECT button.

The system being selected.

The systems on this dialog box can be selected.

When this mark is displayed as black, more computer system modes will be available. Move the arrow to this mark and then press the SELECT button, and another mode will be displayed.

Closes the SYS- TEM Menu.