COMPUTER MODE
Auto Image Function
The Auto Image function is provided to automatically adjust Fine sync., Total dots, and Picture Position for most computers.
1 | Press the MENU button and the | |
| Press the POINT LEFT/RIGHT buttons to select AUTO IMAGE | |
| and press the SELECT button. | |
| Another dialog box AUTO IMAGE Menu will appear. | |
2 | Move the arrow to an item that you want to adjust by pressing the | |
POINT UP/DOWN button. Change the setting On or Off by | ||
| pressing the SELECT button. | |
|
| |
Fine sync | Adjust the picture as necessary to eliminate flicker from | |
|
| the display. This item can be adjusted manually. (Refer |
|
| to page 27.) |
|
| |
Total Dots | The number of the total dots in one horizontal period. | |
|
| This item can be adjusted manually. (Refer to page 27.) |
|
|
|
| Position | Adjustment of the position of the image. This item can |
3 |
| be adjusted manually. (Refer to page 29.) |
Move the arrow to "Go!" and press the SELECT button to start the | ||
Auto Image function. | ||
| This adjustment can be executed by pressing AUTO IMAGE | |
| button on the Top Control and the Remote Control. | |
NOTE : The Fine sync., Total dots, and Picture Position of some computers may not be fully adjusted with the Auto Image Function. In that case, manually adjustments is required to make fine image. (Refer to PICTURE IMAGE ADJUSTMENT on page 27 to adjust "Fine sync." or "Total dots" and PICTURE POSITION ADJUSTMENT on page 29 to adjust Picture Position.)
Move the arrow to the item and then press the SELECT button.
Starts the adjust- ment on the item set to "On".
Closes the PICTURE
IMAGE ADJUSTMENT
Menu.
Normal Function
The normal picture level is preset on this projector by the factory and can be restored anytime by pressing the NORMAL button (located on the Top Control or on the Remote Control Unit). The "Normal" display will be displayed on the screen for a few seconds.
Normal
28