Setting
Logo
This function decides what to be displayed when starting up.
User ···· the image you captured Default ···· the
Off ····
Capture
This function is used to capture the image being projected and use it for a
To capture the image, select [Yes]. To cancel the Capture function, select [No].
Before capturing an image, select Standard in the Image Select Menu to capture a proper image. (See page 30, 36.)
A signal from a computer can be captured up to XGA(1024 x 768). A signal from video equipment can be captured except for 720p, 1035i, and 1080i. When capturing the image that has been adjusted by the Keystone function, the adjustment data is automatically reset and the projector captures an image without keystone adjustment.
Capture
Select [Yes] to capture the projected image.
Press the SELECT button at this icon to display other items.
Select [Yes] to stop capturing.
Ceiling
When this function is “On,” the picture is top/bottom and left/right reversed. This function is used to project the image from a ceiling mounting the projector.
Rear
When this function is “On,” the picture is left/right reversed. This function is used to project the image to a rear projection screen.
Terminal
The COMPUTER IN 2/MONITOR OUT terminal on the back of the projector can be used as computer input or monitor output by switching Terminal with the Point Left/Right button.
To use the terminal as computer input or RGB Scart
Terminal cannot be switched into Monitor out after selecting Computer 2. In this case, select other input source such as Computer 1 or Video, and you will select Terminal.
Standby mode
This function is available when using Multi Card Director optionally supplied, and it reduces standby energy when selecting Eco.
Eco ···· reduces standby energy.
Normal ···· consumes normal standby energy.
Ceiling |
Rear |
Standby mode
Press the SELECT button at this icon to display previous items.
Move the pointer to item and then press POINT LEFT/RIGHT button(s).
40