Operation
Start up
1.Plug the power cord into the projector and
into a wall socket. Turn on the wall socket switch (where fitted). Check that the Power indicator on the projector lights orange after power has been applied..
2.Remove the lens cap. If it is left on, it could become deformed due to the heat produced by the
projector lamp.
3. Press and hold (for 2 seconds)
Power on the projector or remote
control to start the projector. As soon as the lamp lights up, a "Power On Tone" will be heard. The Power indicator light flashes green and stays green when the projector is on.
The start up procedure takes about 30 seconds. In the later stage of start up, a startup logo is projected.
(If necessary) Rotate the focus ring to adjust the image clearness.
• If you don't want to activate Power on/off tone, you can enter the OSD menu to disable this function. See "Mute (off)" on page 42 for details.
•If the projector is still hot from previous activity, it will run the cooling fan for approximately 90 seconds before energizing the lamp.
4.If you are prompted for a password, press the arrow buttons to enter a four digit password. See "Utilizing the password function" on page 26 for details.
5.Switch on all of the connected equipment.
The projector will start to search for input signals. The current input source being scanned displays in the center of the screen. The searching message will continue displaying until an input source signal is found.
You can press SOURCE on the projector or remote control to select your desired input signal. See "Switching input signal" on page 28 for details.
•A message of "Resolution Reminding" will display when the projector detects that the resolution of the input source is not XGA.