BenQ MP721C user manual DVI cables

Page 26

The final connection path should be like that shown in the following diagram:

A/V device

Component Video to VGA (D-Sub) adaptor cable

Audio cables

DVI cables

•The projector is only capable of playing mixed mono audio, even if a stereo audio input is connected. See "Connecting Audio" on page 20 for details.

•Component Video is the only video output that delivers native 16:9 aspect ratio picture.

If you connect the projector to a High Definition TV (HDTV) tuner, the following standards are supported:

•	480i	•	480p
•	576i	•	576p
•	720p (50/ 60 Hz)	•	1080i (50/ 60 Hz)

If the selected video image is not displayed after the projector is turned on and the correct video source has been selected, check that the Video source device is turned on and operating correctly. Also check that the signal cables have been connected correctly.

22 Connection

Image 26

Contents Welcome Copyright DisclaimerTable of contents Iv Table of contents Future reference Projector lamp is on Important safety instructionsRefer servicing to qualified service personnel Do not look straight at the projectorSafety Instructions Allow at least 50 cm clearance from walls 10000 Feet Important safety instructionsBedding or any other soft surface Safety Instructions Introduction Projector featuresIntroduction Shipping contents Rear side Projector exterior viewFront/upper side Lower/side viewTurns the projector on or off Controls and functionsProjector Exit Remote controlAdjusts the focus of the projected image FreezeEnters presentation timer setting directly 3Left, Right4Pull out the battery holder Remote control effective rangeReplacing the remote control battery Push the holder into the remote controlPositioning your projector Choosing a locationSafety instructions for ceiling mounting of the projector Obtaining a preferred projected image size Positioning your projector 1219 Maximum zoom Minimum zoomScreen Center of lens Projection distance 1500Projector with the wireless module Wireless connection optionalConnecting a computer or monitor ConnectionVGA to Cable Connecting a monitor Best video quality Connecting Video source devicesConnecting Audio Better video qualityConnecting a Component Video source device DVI cables Connecting an S-Video source device To connect the projector to an S-Video source deviceConnecting a composite Video source device Operation OperationStart up Left 3 or Right4 Utilizing the password functionSetting a password Changing the password If you forget the passwordEntering the password recall procedure Adjusting the projection angle Switching input signalAdjusting the projected image Correcting keystone Auto-adjusting the imageFine-tuning the image size and clarity Selecting the aspect ratio For exampleSelecting a picture mode PC Signal InputYou can set the blank time Hiding the imageCreating your own startup screen MyScreen function Ii.Click Next Iii. Click Next To execute MyScreen utilityIcon Click MyScreen to begin downloadVi. Click Close when the window below displays Activating panel key lockSetting the presentation timer Freezing the imageShutting down the projector Utilizing FAQ functionDisconnect the power cord from the wall socket Press and hold BLANK/Q? on the projector for 3 secondsMenu operation Menu systemUsing the menus Picture menu Sharpness ColorTint Pro-Picture menu Setting menu Advanced menu High Altitude Mode offTimer Auto OffEquivalent ResolutionInformation menu Lamp Hour SystemMaintenance Care of the projectorCalculation of lamp hour Install a new lamp for optimal performanceLamp information New lamp should be fitted to avoidReplacing the lamp Remove the lamp cords from the slots Locators on the projector MaintenanceRemove the lamp cover from the projector Tighten the screw that secures the lamp Temperature informationResetting the lamp counter Restart the projectorPowering up IndicatorsStand-by mode IllustrationLight Status & Description Power Temp Lamp Thermal events Make sure that it is switched on TroubleshootingPlug the power cord into the AC inlet on You do not remember the passwordSpecifications Projector specificationsSupported timing for Component-YPbPrinput Timing chartSupported timing for PC input Supported timing for Video and S-Video inputsDimensions Mm W x 94 mm H x 219.5 mm D 278 64.3 Unit mm SpecificationsWarranty Limited warrantyEEC statement Regulation statementsFCC statement MIC statement

Related manuals

Manual 1 pages 55.09 Kb

DVI cables

1080i (50/ 60 Hz)