BenQ MP723 user manual Fine-tuning the image quality in user modes, Setting the User 1/User 2 mode

YPbPr/S-Video/Video/HDCP Signal Input

1.Dynamic mode: Is suitable for playing gamebox-based video games in a normal living room lighting level environment.

2.Standard mode (Default): Is appropriate for viewing colorful movies, video clips from digital cameras or DVs.

3.Cinema mode: Is suitable for enjoying dark movies or DVD movies best viewed in a blackened (little light) home cinema or lounge room environment.

4.User 1/User 2 mode: Recalls the settings customized based on the current available picture modes. See "Setting the User 1/User 2 mode" on page 36 for details.

Setting the User 1/User 2 mode

There are two user-definable modes if the current available picture modes are not suitable for your need. You can use one of the picture modes (except the User 1/2) as a starting point and customize the settings.

1.Press MENU/EXIT to open the On-Screen Display (OSD) menu.

2.In the PICTURE menu, highlight Picture Mode and press / to select User 1 or User 2.

3.Press to highlight Reference Mode.

This function is only available when User 1, or User 2 mode is selected up in the Picture Mode sub-menu item.

4.Press / to select an picture mode that is closest to your need.

5.Press to select a menu item to be changed and adjust the value with / . See "Fine-tuning the image quality in user modes" below for details.

6.When all settings have been done, highlight Save Settings and press Mode/enter on the projector or ENTER on the remote control to store the settings.

7.The confirmation message 'Setting Saved' displays.

Fine-tuning the image quality in user modes

According to the detected signal type, there are some user-definable functions available when User 1 or User 2 is selected. You can make adjustments to these functions based on your needs.

Adjusting Brightness

Press BRIGHTNESS on the remote control or highlight Brightness in the PICTURE menu and adjust the values

by pressing / on the projector or remote control.

+30 +50 +70

The higher the value, the brighter the image. And lower the setting, darker the image. Adjust this control so the black areas of the image appear just as black and that detail in the dark areas is visible.

Adjusting Contrast

Press CONTRAST on the remote control or highlight Contrast in the PICTURE menu and adjust the values

by pressing / on the projector or remote control.

+30 +50 +70

The higher the value, the greater the contrast. Use this to set the peak white level after you have previously adjusted the Brightness setting to suit your selected input and viewing environment.

36 Operation