BenQ MP723 user manual Warranty and Copyright information, Limited warranty, Disclaimer

Page 65

Warranty and Copyright information

Limited warranty

BenQ warrants this product against any defects in material and workmanship, under normal usage and storage.

Proof of purchase date will be required with any warranty claim. In the event this product is found to be defective within the warranty period, BenQ's only obligation and your exclusive remedy shall be replacement of any defective parts (labor included). To obtain warranty service, immediately notify the dealer from which you purchased the product of any defects.

Important: The above warranty shall be void if the customer fails to operate the product in accordance with BenQ's written instructions, especially the ambient humidity must be in- between 10% and 90%, temperature in-between 0°C and 35°C, altitude lower than 4920 feet, and avoiding to operate the projector in a dusty environment. This warranty gives you specific legal rights, and you may have other rights which vary from country to country.

For other information, please visit www.BenQ.com.

Copyright

Copyright 2007 by BenQ Corporation. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission of BenQ Corporation.

Disclaimer

BenQ Corporation makes no representations or warranties, either expressed or implied, with respect to the contents hereof and specifically disclaims any warranties, merchantability or fitness for any particular purpose. Further, BenQ Corporation reserves the right to revise this publication and to make changes from time to time in the contents hereof without obligation to notify any person of such revision or changes.

*DLP, Digital Micromirror Device and DMD are trademarks of Texas Instruments. Others are copyrights of their respective companies or organizations.

Warranty and Copyright information

65

Image 65
Contents Welcome Table of contents Refer servicing to qualified service personnel Important safety instructionsFuture reference Projector lamp is on Do not look straight at the projectorSafety Instructions Resulting in damage to the projector Bedding or any other soft surfaceAllow at least 50 cm clearance from walls Ceiling mounting the projector Introduction Projector featuresIntroduction Shipping contents Lamp cover Projector exterior viewFront/upper side Rear/lower side Projector Controls and functionsCapture Remote controlOperating the Laser pointer Indicator light 22. D. Zoom +Approx.15 Remote control effective rangeReplacing the remote control batteries Positioning your projector Set Rear Ceiling in the System Setup BasicChoosing a location Front TableObtaining a preferred projected image size Page Screen Center of lens Projection distance Maximum zoom Minimum zoom1219 1500Connection Connecting a computer or monitorConnecting a computer Iii With a VGA cable With a VGA to DVI-A cable Connecting a monitorConnecting Audio Connecting Video source devicesBest video quality Better video qualityConnecting a DVI source device To connect the projector to a Component Video source device Connecting a Component Video source deviceDevice Connecting an S-Video source deviceTo connect the projector to an S-Video source device To connect the projector to a composite Video source device Connecting a composite Video source deviceOperation Projection lamp Press I I Power on the projector or remoteStarting up the projector OperationUse / to highlight the System Setup Basic menu Using the menusUtilizing the password function Using a security cable lockSecuring the projector Removing the control keypad on the projectorIf you forget the password Setting a passwordTo the Security Settings Respectively represent 4 digitsChanging the password Entering the password recall procedureDisabling the password function Enter a new passwordChanging Color Space Switching input signalAdjusting the projection angle Adjusting the projected imageAuto-adjusting the image Fine-tuning the image size and clarityCorrecting keystone On the projector or remote ControlAbout the aspect ratio Selecting the aspect ratioSelecting a picture mode Using Wall ColorPC/DVI-A/DVI-D Signal Input Optimizing the imageSetting the User 1/User 2 mode Fine-tuning the image quality in user modesAdjusting Brightness Adjusting ContrastAdjusting Tint Adjusting ColorAdjusting Sharpness Adjusting Brilliant Color3D Color Management Every adjustment made will reflect toYou want the timer to show up on the screen by Setting the presentation timerHow to use the Timer ON/SHOW button? To cancel the timer, perform the following stepsRemote paging operations Button is a multi-functional keyFreezing the image Hiding the imageLocking control keys Utilizing FAQ functionGo to the System Setup Basic Panel Key Lock Operating in a high altitude environment Setup Advanced High Altitude Mode, select OnCreating your own startup screen To activate the High Altitude Mode, go to the SystemAdjusting the sound level Adjusting the soundTurning off the Power on/off ring tone Personalizing the projector menu displayApproximately 90 seconds to cool down the projector Shutting down the projectorMenu system Menu operationAdvanced BasicSource menu Display menuPicture menu System Setup Basic menu System Setup Advanced menu Information menu Care of the projector MaintenanceSetting Auto Power Off Setting Lamp Mode as EconomicLamp information Getting to know the lamp hourTiming of replacing the lamp Replacing the lamp Loosen the screw that secures the lamp MaintenanceTighten the screw that secures the lamp Restart the projector Resetting the lamp timerIndicators Remote control does not work TroubleshootingProjector does not turn on No pictureProjector specifications SpecificationsMm W x 131.30 mm H x 304.99 mm D 274.87 48.57 Specifications DimensionsHorizontal Vertical Pixel Resolution Frequency Mode KHz MHz Timing chartSignal Format Horizontal Vertical Frequency Frequency kHz Supported timing for PC including DVI-D inputSupported timing for Video and S-Video inputs 15.73 Specifications15.73 15.63Limited warranty Warranty and Copyright informationCopyright DisclaimerFCC statement Regulation statementsEEC statement Weee directive