Adjusting the sound
The sound adjustments made as below will have an effect on the projector speaker. Be sure you have made a correct connection to the projector audio input. See "Connection" on page 18 for how the audio input is connected.
Muting the sound
To temporarily turn off the sound,
1.Press MENU/EXIT and then press 
/ 
until the SYSTEM SETUP: Advanced menu is highlighted.
2.Press 
to highlight Audio Settings and press Mode/enter on the projector or ENTER on the remote control. The Audio Settings page displays.
3.Highlight Mute and press 
/ 
to select On.
Adjusting the sound level
To adjust the sound level,
1.Repeat steps
2.Press 
to highlight Volume and press 
/ 
to select a desired sound level.
Turning off the Power on/off ring tone
To turn off the ring tone,
1.Repeat steps
2.Press 
to highlight Power on/off ring tone and press 
/ 
to select Off.
The only way to change Power on/off ring tone is setting On or Off here. Setting the sound mute or changing the sound level will not affect the Power on/off ring tone.
Personalizing the projector menu display
The
•Menu Display Time in the SYSTEM SETUP: Advanced > Menu Settings menu sets the length of time the OSD will remain active after your last button press. The time length ranges from 5 to 30 seconds in 
/ 
to select a suitable time.
•Menu Position in the SYSTEM SETUP: Advanced > Menu Settings menu sets the OSD position in five locations. Use 
/ 
to select a preferred position.
•Language in the SYSTEM SETUP: Basic menu sets your familiar language for the On- Screen (OSD) Menus. Use 
/ 
to select your language.
•Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo screen to be displayed during projector 
/ 
to select a screen.