Personalizing the projector menu display
The
•Menu Display Time in the SYSTEM SETUP: Advanced > Menu Settings menu sets the length of time the OSD will remain active after your last button press. The time length
ranges from 5 to 30 seconds in 
Left/ 
Right to select a suitable time.
•Menu Position in the SYSTEM SETUP: Advanced > Menu Settings menu sets the OSD position in five locations. Use 
Left/ 
Right to select a preferred position.
•Language in the SYSTEM SETUP: Basic menu sets your familiar language for the On- Screen (OSD) Menus. Use 
Left/ 
Right to select your language.
•Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo screen to be displayed during projector 
Left/ 
Right to select a screen.
Shutting down the projector
1.Press 
Power and a confirmation message will display prompting you.
If you don't respond in a few seconds, the message will disappear.
2.Press 
Power a second time. The Power indicator light flashes orange, the projection lamp shuts down, and the fans will continue to run for approximately 120 seconds to cool down the projector.
POWER OFF
Press button again to power off
Press any button to cancel
To protect the lamp, the projector will not respond to any commands during the cooling process.
3.If the projector will not be used for a long
period of time, disconnect the power cord from the wall socket.
• Do not unplug the power cord before the projector shutdown sequence is complete or during the
• If the projector is not properly shut down, to
protect the lamp, when you attempt to
cool down. Press Power again to start the projector after the fans stop and the Power indicator light turns orange.