BenQ W1200 user manual Do not turn the power on with the lamp Cover removed

Page 53

3.Remove the lamp cover by (a) sliding the cover toward the side of the projector and (b) lifting it off.

• Do not turn the power on with the lamp	(b)	(a)
cover removed.

•Do not insert your fingers between the lamp and the projector. The sharp edges inside the projector may cause injuries.

4. Loosen the screws that secure the lamp.

5.Lift the handle so that it stands up. Use the handle to slowly pull the lamp out of the projector.

•Pulling it too quickly may cause the lamp to break and scatter broken glass in the projector.

•Do not place the lamp in locations where water might splash on it, children can reach it, or near flammable materials.

• Do not insert your hands into the projector after the lamp is removed. If you touch the optical components inside, it could cause color unevenness and distortion of the projected images.

6.Insert the new lamp into the lamp compartment and make sure it fits in the projector.

Maintenance 53

Image 53

Contents W1100/W1200 Digital Projector WelcomeTable of contents Important safety instructions Safety Instructions Do not block the ventilation holes Safety Instructions Introduction Projector featuresShipping contents Front/upper side Projector exterior viewProjector Controls and functionsCeiling mounting the projector Size, PIP Pos, PIP Active Remote controlLeft Right Test II PowerColor Replacing the remote control battery Choosing a location Positioning your projectorObtaining a preferred projected image size Positioning your projector Min. zoom Projection dimensionsConnection ConnectionConnection Video Normal Connecting Video source devicesStarting up the projector OperationAuto-adjusting the image Adjusting the projected imageAdjusting the projection angle Correcting keystone Fine-tuning the image size and clarityUse / to highlight the System Setup menu Using the menusUtilizing the password function Using a security cable lockSetting a password If you forget the passwordDisabling the password function Entering the password recall procedureChanging the password Changing Color Space Switching input signalSelecting the aspect ratio Magnifying and searching for detailsPicture Letter Box format picture Setting the User 1/User 2/User 3 mode Selecting a picture modeGo to the Picture Basic Basic Picture Mode menu Optimizing the imageAdvanced picture quality controls Fine-tuning the image qualityFine-Tuning a Color Temperature Selecting a Color TemperatureAdjusting Brilliant Color Selecting a Gamma Selection3D Color Management Selecting a Film Mode Setting the Sleep TimerHiding the image Freezing the imageTo activate the High Altitude Mode Adjusting the soundOperating in a high altitude environment Turning on/off the SRSAdjusting the Treble level Adjusting the sound levelAdjusting the Bass level Turning on the Power on/off Ring ToneVideo Shutting down the projector Personalizing the projector menu displayMenu system Menu operationAudio System Setup Description of each menu Picture ModeISF Source SRS Language Projector Position Menu Settings System Setup menu Information menu Care of the projector MaintenanceSetting Auto Power Off Setting Lamp Mode as EconomicLamp information Getting to know the lamp hourStatus Message Timing of replacing the lampReplacing the lamp Do not turn the power on with the lamp Cover removed Resetting the lamp timer Indicators Troubleshooting Optical SpecificationsCeiling mount installation DimensionsSupported timing for PC input Timing chartSupported timing for Hdmi input Supported timing for Component-YPbPrinput Patents for W1100/W1200 Warranty and Copyright informationFCC statement Regulation statementsRegulation statements Regulation statements