Ampro Corporation P/N 5001795A REV A manual Connecting the Power Supply

Page 10

Chapter 1

ReadyPanel Setup

Connecting the Power Supply

8)Connect the DC Power In adapter cable.

•Plug in the DC Power In adapter cable, provided with the ReadyPanel, to the DC Power In connector on the ReadyPanel. See Figure 1-3.

Note: Using an ATX power supply requires the PS-ON signal grounded to power on.

9)Connect the power supply.

•Plug in the free end of the power adapter cable to an ATX or AT power sup- ply.

DC Power In

Adapter Cable

Figure 1-4. Angle View of ReadyPanel I/O Panel

6

User’s Guide

ReadyPanel

Image 10

Contents ReadyPanelTM User’s Guide Audience Assumptions Contents User’s Guide ReadyPanel Using this Guide ReadyPanel SetupRequirements Power Specifications What’s in the BoxSetting Up the Work Space PreparationsTouch Screen Installing Mounting HardwareLocating the I/O Connectors Air VentsVGA Connecting the Power Supply Angle View of ReadyPanel I/O PanelApplying Power to the ReadyPanel Linux 2.6 OS is shown as an exampleUser’s Guide ReadyPanel Opening the ReadyPanel Enclosure ReadyPanel ComponentsTools Required To remove the cover of the ReadyPanelExploded View of ReadyPanel Assembly with Cover and Screws Replacing the ReadyPanel Memory To Remove the Sodimm from the ReadyPanel See -2and FigureExploded View of Enclosure with Chassis and Board To Install the Sodimm into the ReadyPanel Bottom view of Chassis with Sodimm in SocketUser’s Guide ReadyPanel Appendix a Technical Support Http//ampro.custhelp.comAppendix a