Ampro Corporation P/N 5001795A REV A manual ReadyPanel Components, Tools Required

Page 13

Chapter 2 ReadyPanel Components

This chapter discusses components inside the ReadyPanel enclosure. These components include the memory, display power inverter, touch screen controller card, cables, and the ReadyBoard Single Board Computer (SBC).

NOTE Refer to the specific ReadyBoard Reference Manual for more information than this chapter provides.

ReadyPanel Assembly Procedures

The following procedures describe how to gain access to the ReadyPanel internal components and the ReadyBoard memory.

Tools Required

Use these tools to install and remove components into or out of the ReadyPanel enclosure.

•Phillips #2 screwdriver

•Anti-static service kit - Use a complete anti-static service kit (or the equivalent) to remove or install the ReadyBoard. A complete anti-static service kit should include a static-dissipating work surface, a chassis clip lead, and a wrist or ankle strap.

Opening the ReadyPanel Enclosure

Always use the following procedure when gaining access to the ReadyPanel’s internal components.

To remove the cover of the ReadyPanel

1.Initiate a shut down sequence through the OS, or hold in the reset switch for 4-6 seconds to turn off power. See Figure 1-3 on page 5.

2.Make sure the power LED on the front panel is completely inactive. See Figure 1-3 on page 5.

3.Disconnect the power cable from the DC Power In connector of the I/O panel.

CAUTION Components on the ReadyBoard are sensitive to static electricity and can be easily damaged by improper handling. Do the following when handling the ReadyBoard.

Always use an anti-static wrist/ankle strap and a grounding mat.

Before you handle the ReadyBoard, touch a grounded, unpainted metal surface to discharge any static electricity.

4.Remove the cover from the ReadyPanel enclosure. See Figure 2-1.

a.Turn over the ReadyPanel so that the touch screen faces down on an anti-static surface.

b.Remove the four cover screws that mount the cover to the enclosure.

c.Lift the cover up from the enclosure.

d.Unplug the fan cable from the fan connector on the ReadyBoard.

e.Set aside the cover and screws for later re-installation.

ReadyPanel

User’s Guide

9

Page 12 Page 14
Image 13
Page 12 Page 14
Contents ReadyPanelTM User’s Guide Audience Assumptions Contents User’s Guide ReadyPanel Using this Guide ReadyPanel SetupRequirements What’s in the Box Power SpecificationsPreparations Setting Up the Work SpaceLocating the I/O Connectors Installing Mounting HardwareTouch Screen Air VentsVGA Angle View of ReadyPanel I/O Panel Connecting the Power SupplyLinux 2.6 OS is shown as an example Applying Power to the ReadyPanelUser’s Guide ReadyPanel Tools Required ReadyPanel ComponentsOpening the ReadyPanel Enclosure To remove the cover of the ReadyPanelExploded View of ReadyPanel Assembly with Cover and Screws To Remove the Sodimm from the ReadyPanel See -2and Figure Replacing the ReadyPanel MemoryExploded View of Enclosure with Chassis and Board Bottom view of Chassis with Sodimm in Socket To Install the Sodimm into the ReadyPanelUser’s Guide ReadyPanel Http//ampro.custhelp.com Appendix a Technical SupportAppendix a
Top Page Image Contents