Ampro Corporation P/N 5001795A REV A Installing Mounting Hardware, Locating the I/O Connectors

Chapter 1 ReadyPanel Setup

Installing Mounting Hardware

6)Install the appropriate mounting hardware.

•Install the mounting hardware for surface or wall mounting to the bottom of the ReadyPanel. See Figure 1-2.

Note: Make sure the mounting plate clears the fan intake and provides enough height to allow for unrestricted air flow.

Make sure not to drive the ends of the screws further than two screw threads past the ends of the PEM nuts located on the inside of the enclosure cover.

Touch Screen	Air Vents
	(Rear)

Air Vents

(Front)

Enclosure
Cover
75mm (2.95")
(2.95")	Cooling Fan
	(Bottom)
75mm	Suggested
	Mounting Plate
Figure 1-2.	Angle View of Enclosure with Mounting Hardware

NOTE The Mounting holes in the bottom of the ReadyPanel conform to the FDMI (Flat Display Mounting Interface) standard for monitor mounting.

Locating the I/O Connectors

7)Locate the I/O connectors on the front of the ReadyPanel.

Refer to Figure 1-3and Table 1-2for locations and descriptions of the connectors and controls before making connections or powering on the ReadyPanel.

4 User’s Guide ReadyPanel