RS232 Connection
1. Connection:
The illustration of connection between PC and Projector is shown below.
<CAUTION>
Make sure that your computer and projector are turned off before connection. Power on the computer first, and then plug the power cord of the projector. (It may cause Com port incorrect function, if you do not follow this instruction)
Adapters may be necessary depending on the PC connected to this projector. Please contact with your dealer for further details.
2.Hardware connection <Download cable>
<Pin assignment for this two end>
<Interface Settings>
|
|
Baud Rate | 9600 bps |
Data Length | 8 bit |
Parity Check | None |
Stop Bit | 1 bit |
Flow Control | None |
Command Category
Refer to Appendix A
86