Onkyo TX-SR 803E, TX-SR8370 Connecting a CD Player, Connecting a Turntable, Step, CD player

TX-SR803_En.book Page 33 Friday, August 26, 2005 9:26 AM

Connecting Your Components—Continued

Connecting a CD Player

Step 1:

Choose a connection that matches your CD player ( a , b , or c ), and then make the connection.

b COAXIAL IN 2

c OPTICAL

IN 3

a IN

L

R

CD

Connect one or the other

	L	R
COAXIAL	OPTICAL	AUDIO
OUT	OUT	OUT

CD player

•With connection , you can listen to and record audio from the CD player and listen in Zone 2.

•To connect the CD player digitally, use connection or c . (For recording, use and b , or and .)

Connection		AV receiver	Signal flow	CD or turntable
	a	CD IN L/R	⇐	Analog audio L/R output
		DIGITAL COAXIAL IN 2	⇐	Digital coaxial output
	b
	c	DIGITAL OPTICAL IN 3	⇐	Digital optical output

Connecting a Turntable

The AV receiver’s PHONO IN is for use with a moving magnet (MM) type cartridge.

Use an analog audio cable to connect the AV receiver’s PHONO IN L/R jacks to the audio output on your turn- table.

Notes:

•If your turntable has a ground wire, connect it to the AV receiver’s GND screw. With some turntables, con- necting the ground wire may produce an audible hum. If this happens, disconnect it.

•If your turntable has a moving coil (MC) type car- tridge, you’ll need a commercially available MC head amp or MC transformer. Connect your turntable to the head amp or transformer, and connect that to the AV receiver’s PHONO IN L/R jacks.

•You can also use a phono equalizer to connect a turn- table with an MC-type cartridge. See the phono equal- izer’s manual for details.

IN

L

R

PHONO

AUDIO

OUTPUT

L

R

33