Onkyo TX-SR703E, TX-SR8370, TX-SR803, TX-SR 803E Getting to Know the AV Receiver, Front Panel

TX-SR803_En.book Page 7 Friday, August 26, 2005 9:26 AM

Getting to Know the AV Receiver

Front Panel

1 2 3 4 5 6 7

STANDBY/ON

STANDBY

ZONE 2

POWER

ON OFF

MASTER VOLUME

PURE AUDIO MULTI CH DVD VIDEO 1 VIDEO 2 VIDEO 3 VIDEO 4 PHONO TAPE TUNER CD DISPLAY

			PUSH TO OPEN
9	J	Front flap	Push here to open

the flap

8 Not North American and Australian models

The actual front panel has various logos printed on it. They are not shown here for clarity. For detailed information, see the pages in parentheses.

ASTANDBY/ON button (39)

Sets the AV receiver to On or Standby.

BSTANDBY indicator (39)

Lights up when the AV receiver is on Standby and flashes while a signal is being received from the remote controller.

CZONE 2 indicator (83)

Lights up when Zone 2 is on.

DRemote-control sensor (13)

Receives control signals from the remote controller.

EDisplay

See “Display” on page 9.

FDISPLAY button (59)

IPURE AUDIO button and indicator (60)

Selects the Pure Audio listening mode. The indica- tor lights up when this mode is selected. Pressing this button again selects the previous listening mode.

JInput selector buttons (48)

Select the following input sources: MULTI CH, DVD, VIDEO 1, VIDEO 2, VIDEO 3, VIDEO 4, PHONO, TAPE, TUNER, or CD.

The [MULTI CH] button selects the multichannel DVD input.

Displays various information about the currently selected input source.

GMASTER VOLUME control (48)

Sets the volume of the AV receiver to –∞dB, –81 dB, –80 dB through +18 dB (relative display).

The volume level can also be displayed as an abso- lute value. See “Volume Setup” on page 78.

HPower switch

American and Australian models don’t have this switch.

This is the main power switch. When set to OFF, the AV receiver is completely shutdown. When set to ON, it’s in Standby mode and the STANDBY indi- cator lights up.

7