Onkyo TX-SR 803E Connecting the Power Cords of Other Components, Connecting the RS232 Port

TX-SR803_En.book Page 38 Friday, August 26, 2005 9:26 AM

Connecting Your Components—Continued

Connecting the Power Cords of Other Components

The AV receiver has AC outlets on its rear panel that can be used to connect the power cords of other components that you intend to use with the AV receiver. These com- ponents can then be left turned on so that they turn on and off as and when the AV receiver is turned on and set to Standby.

AC OUTLETS

	AC 120V 60 Hz
	SWITCHED
	TOTAL 120W 1A MAX.
AC OUTLETS
AC 230-240V 50 Hz
SWITCHED
TOTAL 100W MAX.
European and some	American model

Asian models

Caution:

•Make sure that the total capacity of the components that you connect to the AC OUTLETS does not exceed the stated capacity (e.g., TOTAL 120 W).

Note:

•Onkyo components connected via should be con- nected directly to a wall outlet, not an AC OUTLET on the AV receiver.

•The number of AC OUTLETS, socket type, and total capacity depends on the country in which you pur- chased the AV receiver.

Connecting the RS232 Port

American and Australian models do not have this port. This port is for connecting the AV receiver to home auto- mation equipment and external controllers.

Connecting the Power Cord

•Before connecting the power cord, connect all your speakers and AV components.

•Connect the AV receiver’s power cord to a suitable wall outlet.

•Turning on the AV receiver may cause a momentary power surge that might interfere with other electrical equipment on the same circuit. If this is a problem, plug the AV receiver into a different branch circuit.

38