Onkyo TX-SR703, TX-SR8370, TX-SR803 Common Functions, Using the Sleep Timer, Using Headphones

TX-SR803_En.book Page 59 Friday, August 26, 2005 9:26 AM

Common Functions—Continued

Using the Sleep Timer

With the sleep timer, you can set the AV receiver so that it turns off automatically after a specified period.

SLEEP Press the remote controller’s

[SLEEP] button repeatedly to select the required sleep time.

You can set the sleep time from 90 to 10 minutes in 10 minute steps.

The SLEEP indicator appears on the display when the sleep timer has been set, as shown. The specified sleep time appears on the display for about 5 sec- onds, then the previous display reap- pears.

SLEEP indicator

To cancel the sleep timer, press the [SLEEP] button repeatedly until the SLEEP indicator disappears.

To check the remaining sleep time, press the [SLEEP] button. Note that if you press the [SLEEP] button while the sleep time is being displayed, you’ll shorten the sleep time by 10 minutes.

Using Headphones

For private listening, you can connect a pair of stereo headphones (1/4-inch phone plug) to the AV receiver’s PHONES jack.

STANDBY/ON

STANDBY

ZONE 2

POWER

ON OFF

PURE AUDIO

PHONES
ZONE 2	OFF

Notes:

•Always turn down the volume before connecting your headphones.

•The speakers are turned off while the headphones plug is inserted in the PHONES jack. (The Zone 2 speakers are unaffected.)

•When you connect a pair of headphones, the listening mode is set to Stereo, unless it was set to Pure Audio, Mono, Stereo, or Direct, in which case it stays the same.

Displaying Source Information

You can display various information about the current input source as follows.

Remote	Press the [DISPLAY] button
controller	repeatedly to cycle through the
DISPLAY	available information.
AV receiver
DISPLAY

The following information can typically be displayed:

Input source & volume

Signal format* or sampling frequency

Input source & listening mode

*If the input signal is analog, no format information is displayed. If the input signal is PCM, the sampling fre- quency is displayed. If the input signal is digital but not PCM, the signal format is displayed.

On the TX-SR803/803E, if the input signal is multichan- nel PCM, the sampling frequency and signal format will be displayed. Information is displayed for about 3 sec- onds, then the previous display reappears.

Interpreting Surround Channel Information

AB C

A:The number of front channels (front left, front right, and center).

B:The number of surround channels (surround left and surround right). If there’s surround back channel information, this number will be 3.

C:LFE channel for subwoofer (1 means yes).

59