Onkyo TX-SR703E, TX-SR8370, TX-SR803 Controlling Other Components, Resetting the Remote Controller

TX-SR803_En.book Page 87 Friday, August 26, 2005 9:26 AM

Controlling Other Components—Continued

Remote Control Codes for Onkyo Components Connected via

Onkyo components that are connected via are con- trolled by pointing the remote controller at the AV receiver, not the component. This allows you to control components that are out of view, in a rack, for example.

1	Make sure the Onkyo component is con-
	nected with an	cable and an analog
	audio cable (RCA).
	See page 35 for details.
2	Enter the appropriate remote control code
	for the REMOTE MODE button.

• [DVD] REMOTE MODE button 5002: Onkyo DVD player with

• [CD] REMOTE MODE button 6002: Onkyo CD player with

• [MD] REMOTE MODE button 6008: Onkyo MD recorder with

• [CDR] REMOTE MODE button 6006: Onkyo CD recorder with

See the previous page for how to enter remote control codes.

3 Press the REMOTE MODE button, point the remote controller at the AV receiver, and operate the component.

If you want to control an Onkyo component by pointing the remote controller directly at it, or you want to control

an Onkyo component that’s not connected via , use the following remote control codes:

• [DVD] REMOTE MODE button

5001: Onkyo DVD player without (default)

• [CD] REMOTE MODE button

6001: Onkyo CD player without (default)

• [MD] REMOTE MODE button 6007: Onkyo MD recorder without

• [CDR] REMOTE MODE button 6005: Onkyo CD recorder without

Note:

If you connect an -capable Onkyo MiniDisc or CD recorder to the TAPE IN/OUT jacks, for remote opera- tion to work properly, you must set the input display to MD or CDR (see page 46).

Resetting the REMOTE MODE Buttons

You can reset a REMOTE MODE button to its default remote control code.

1		While holding down the REMOTE
REMOTE MODE MODE button that you want to
CD	DVD	reset, press the TV [	] button.
TV	VCR	The Remote indicator flashes three
CABLE	SAT	times.
CDR	MD

2		Press the REMOTE MODE button
		again.
REMOTE MODE		The Remote indicator flashes twice,
CD	DVD	indicating that the button has been
TV	VCR	reset.
CABLE	SAT
CDR	MD	The [DVD] and [CD] REMOTE

MODE buttons are preprogrammed with remote control codes for control- ling Onkyo DVD players and CD play- ers respectively. When these buttons are reset, the preprogrammed code is restored.

Resetting the Remote Controller

You can reset the remote controller to its default settings.

1	While holding down the
RECEIVER	[RECEIVER] REMOTE MODE but-
	ton, press the [STANDBY] button.
	The Remote indicator flashes five
STANDBY	times.
2	Press the [RECEIVER] REMOTE
RECEIVER	MODE button again.
	The Remote indicator flashes twice,
	indicating that the remote controller
	has been reset.

87