Onkyo TX-SR703, TX-SR8370 OSD Setup, OSD Position, Hdmi Setup TX-SR803/803E Only, Lock Setup

TX-SR803_En.book Page 79 Friday, August 26, 2005 9:26 AM

Advanced Setup—Continued

■Power On Vol

With this preference, you can specify the volume setting to be used when the AV receiver is turned on.

When the Volume Display preference is set to Absolute, the range is 0 to 100. When it’s set to Relative, the range is –∞dB, –81 dB to +18 dB.

To use the same volume level as when the AV receiver was turned off, select “Last.”

The “Power On Vol” cannot be set higher than the “Max- imum Vol” setting.

■Headphones Level

With this preference, you can specify the headphone vol- ume relative to the main volume. This is useful if there’s a volume difference between your speakers and your headphones. The headphones level can be set from –12 dB to +12 dB.

OSD Setup

■Scan Mode

If the text in the onscreen setup menus flickers due to compatibility issues with your TV or projector, select Non-Interlaced.

Interlaced: Default.

Non-Interlaced:Select if the menu text flickers. With some TVs or projectors, the onscreen setup menus may not appear when “Non-Interlaced” is selected. In this case, select this setting again by using the AV receiver’s display, and select “Interlaced.”

Immediate

These settings determine how the operation details are displayed.

■Immediate Display

This preference determines whether operation details are displayed onscreen when an AV receiver function is adjusted.

On: Displayed (default).

Off: Not displayed.

Even when On is selected, operation details are not out- put if the input source is connected to a COMPONENT VIDEO IN or HDMI IN.

■Monitor Type

With this preference, you can specify the aspect ratio of your TV so that the operation details are displayed prop- erly.

4:3: Select if your TV is 4:3 (default). 16:9: Select if your TV is 16:9.

■Display Position

OSD Position

With this preference, you can specify the position of the onscreen setup menus. This is useful with TVs or projec- tors where the menus don’t appear in the center of the screen, or part of the menu is cut off.

To set the menu position, use the arrow [ ]/[ ]/

[ ]/[ ] buttons. To set it back to its default position, press [ENTER].

HDMI Setup (TX-SR803/803E Only)

■HDMI Audio Out

This preference determines whether audio received at the HDMI IN is output by the HDMI OUT. You may want to turn this preference on if your TV is connected to the HDMI OUT and you want to listen to the audio from a component that’s connected to an HDMI IN, through your TV’s speakers. Normally, this should be set to Off.

Off: HDMI audio is not output (default).

On: HDMI audio is output.

With some TVs and input signals, no sound may be out- put even when this setting is set to On.

Lock Setup

■Lock

With this preference, you can protect your settings by locking the setup menus.

When the setup menus are locked, you can still make changes to the settings, but they will not be stored, and the AV receiver will revert to the original settings next time it’s turned on.

Locked: Setup menus locked. Unlocked: Setup menus not locked.

This preference determines where on the screen opera- tion details are displayed.

Bottom: Bottom of the screen (default). Top: Top of the screen.

79