LG Electronics HCS6320 setup guide Installing a CodePlus Feature Card

Installing a CodePlus Feature Card

Slot 6

			Slot 5		CONTROLLER
				HCS6320	Slot
Slot 1	Slot 2	Slot 3	Slot 4		Slot 7	Slot 8	Slot 9	Slot 10	Slot 11	Slot 12
HCS7720	HCS7720	HCS6400	HCS7720	HCS6720 ETHERNET	HCS6400	HCS7720	HCS7720	HCS6400	HCS7720	HCS7720

ASI OUT	ASI OUT
HDMI-IN	HDMI-IN
RESET	RESET
STATUS	STATUS
SERVICE	SERVICE
PORT	PORT
X PORT LINK	X PORT LINK
S/N XXXXXXX	S/N XXXXXXX
MAC ADDRESS	MAC ADDRESS
XX XX XX XX XX	XX XX XX XX XX

ASI OUT	ASI OUT	SERVICE
		PORT
HDMI-IN		RESET
RESET	RESET	STATUS
STATUS	STATUS
SERVICE	SERVICE
PORT	PORT
X PORT LINK	X PORT LINKRF OUT
S/N XXXXXXX	S/N XXXXXXX
MAC ADDRESS	MAC ADDRESS
XX XX XX XX XX	XX XX XX XX XX

ASI OUT	ASI OUT
HDMI-IN	HDMI-IN
RESET	RESET
STATUS	STATUS
SERVICE	SERVICE
PORT	PORT
X PORT LINK	X PORT LINK
S/N XXXXXXX	S/N XXXXXXX
MAC ADDRESS	MAC ADDRESS
XX XX XX XX XX	XX XX XX XX XX

ASI OUT	ASI OUT
HDMI-IN	HDMI-IN
RESET	RESET
STATUS	STATUS
SERVICE	SERVICE
PORT	PORT
X PORT LINK	X PORT LINK
S/N XXXXXXX	S/N XXXXXXX
MAC ADDRESS	MAC ADDRESS
XX XX XX XX XX	XX XX XX XX XX

Note: The CodePlus series products are NOT designed to be hot-swappable!!! Power must be removed to the card frame before any CodePlus transcoder cards are inserted or removed.

Note: All cards used in the card frame must be inserted and removed by qualified service personnel only.

Note: Use extreme care when handling an HCS6320 card. Always observe proper precautions with respect to static electricity and mechanical shock. When not installed in a card frame, return the HCS6320 card to the anti-static bag in which it was shipped.

Note: The card slots in the card frame are NOT all identical!!! An HCS6320 card can only be installed in the CONTROLLER slot. The connector arrangement of Slots 1 to 6 and 7 to 12 is incompatible with the HCS6320.

Note: When installing cards, remove blank cover plates and insert new cards as applicable. For ports that will not be used, leave the blank cover plates in place for proper ventilation and FCC and safety agency compliance.

Follow the procedure below to install the CodePlus feature card.

1.Unpack the HCS6320 unit.

2.Remove the AC power cord for the card frame from the power outlet.

3.Prepare the CONTROLLER slot in the card frame by removing either the blank cover plate or the CodePlus card currently in the slot.

4.Without using force, slide the HCS6320 card into the CONTROLLER slot, and ensure that it is fully inserted.

5.Engage and tighten the top and bottom thumbscrews of the card securely. Note that the thumbscrews should only be finger tight; overtightening may damage the assembly.

6.Refer to the diagram on page 12 for cable connections, and complete the HCS6320 system installation procedure on page 13.

206-4183 11