Nokia CC100 manual Vcci & CE

Page 2

STATEMENT

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and

(2)This device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by one or more of the following measures:

--Reorient or relocate the receiving antenna.

--Increase the separation between the equipment and receiver.

--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

--Consult the dealer or an experienced radio/TV technician for help

VCCI & CE...

Image 2

Contents User Guide Vcci & CE Table of Contents Features GlossaryPacking List ConnectorsLED Indicators Rear PanelConnecting the Cables Detailed cabling of CC100Verification Different Cabling of CC100Installing the CC100 with an amplifier Configuration Methods Use Web BrowserEP User Management System Setup TCP/IP PropertiesSystem Assets Information EP Management Architecture Firmware/Driver FilesMAC Properties Profile Stored the Settings Master HomePNA Properties HpnaCC100 Master Bridge User’s Guide Privacy Mode/Key Summary Profile Status for Master and EP EP HomePNA Properties HpnaMaster/Smart EP Ethernet Properties Ether EP Downstream Igmp v2 Snooping Setup CC100 Master Bridge User’s Guide Delete the Obsolete EP Profile DiagnosisPhysical Connection between Master and EP Administration Administrator Allowed SourceCC100Master Bridge User’s Guide Telnet/Http/SNMP Setup Alert Critical Error Info System LogSystem Time Static MACBackup/Restore Configuration Reboot SystemDefault Setting Upload FirmwareNew System Firmware and Hcna Driver Files System FirmwareCC100Master Bridge User’s Guide CC100 Master Bridge User’s Guide CC100Master Bridge User’s Guide Check the New System Firmware in ‘Upload Area’ Activate the New System Firmware Hcna Driver CC100Master Bridge User’s Guide Also shown on ‘EP Management’ window ‘Upload Area’ Master/EP runs the New Hcna Driver System Firmware and Hcna Driver Version after Upgrade Use Telnet Command Sets for Telnet Console DescriptionEphpnareboot DconfigDefault DiagAllow/deny Reboot HpnarebootIpconfig ServiceCC100 Master Bridge User’s Guide Snmptrapserver SnmptrapsetupSwconfig SntpTime SwtagvlanTftp UpepUse Snmp CC100 Master Bridge User’s Guide 802.1p QoSPriority in Upstream and Downstream TCP/UDP Port NumberSpecifications A N M I S S I O N S P E E D a N D R a N G E R M I N a L D E V I C E S E N D P O I N TLegal & Regulatory Information GNU General Public License Product Warranty Technical Support