Nokia CC100 manual Reboot System, Default Setting, Upload Firmware, Activate Firmware

Page 29

CC100Master Bridge User’s Guide

We bind MAC address 00-60-64-12-34-56 to port LAN1 and MAC address 00-60-64-78-90-00 to port LAN2,

Reboot System

Reboot Master CC100 only and leave the EP untainted.

Default Setting

Restore all settings of the CC100 to factory default, including username/password, IP address, privacy mode/key, etc. Press the ‘Reset’ button locally for about 5 seconds and the CC100 will reboot.

Upload Firmware

Upload ‘Bootcode’ / ‘System firmware’ / ‘Master driver (3110)’ / ‘EP driver (3010 or 3110)’ / ‘Diagnosis utility’ onto the CC100 ‘Upload Area’. Not functional yet, wait to ‘Activate Firmware’ or to ‘Upgrade’ driver. Refer to the following “Example to Upload then Activate System Firmware and HCNA Driver” for more details.

Activate Firmware

To do the real upgrade for ‘Bootcode’ or ‘System Firmware’, make the previous uploaded image functional. Refer the following “Example to Upload then Activate System Firmware and HCNA Driver” for more details.

Backup/Restore Configuration

Use to backup current configuration into a file with filename extension ‘.shc’. Or to restore the CC100 configuration form the previous saved file.

Example to Upload then Activate System Firmware and HCNA Driver

It is a 2-stage file upgrade procedure, first to upload the selected file onto the CC100 flash ROM ‘Upload Area’, then to ‘Activate’ it. A coax network system with one CC100 and two connected Smart EPs.

Current System Firmware and HCNA Driver Version

The system firmware version is ’3.34’ before upgrade, check the ‘Information’ window,

26

Image 29

Contents User Guide Vcci & CE Table of Contents Glossary FeaturesLED Indicators ConnectorsPacking List Rear PanelDetailed cabling of CC100 Connecting the CablesDifferent Cabling of CC100 VerificationInstalling the CC100 with an amplifier Use Web Browser Configuration MethodsEP User Management System Setup TCP/IP PropertiesSystem Assets Information Firmware/Driver Files EP Management ArchitectureMAC Master HomePNA Properties Hpna Properties Profile Stored the SettingsCC100 Master Bridge User’s Guide Privacy Mode/Key Summary EP HomePNA Properties Hpna Profile Status for Master and EPMaster/Smart EP Ethernet Properties Ether EP Downstream Igmp v2 Snooping Setup CC100 Master Bridge User’s Guide Diagnosis Delete the Obsolete EP ProfilePhysical Connection between Master and EP Administration Allowed Source AdministratorCC100Master Bridge User’s Guide Telnet/Http/SNMP Setup System Log Alert Critical Error InfoStatic MAC System TimeDefault Setting Reboot SystemBackup/Restore Configuration Upload FirmwareSystem Firmware New System Firmware and Hcna Driver FilesCC100Master Bridge User’s Guide CC100 Master Bridge User’s Guide CC100Master Bridge User’s Guide Check the New System Firmware in ‘Upload Area’ Activate the New System Firmware Hcna Driver CC100Master Bridge User’s Guide Also shown on ‘EP Management’ window ‘Upload Area’ Master/EP runs the New Hcna Driver System Firmware and Hcna Driver Version after Upgrade Use Telnet Description Command Sets for Telnet ConsoleDefault DconfigEphpnareboot DiagAllow/deny Ipconfig HpnarebootReboot ServiceCC100 Master Bridge User’s Guide Swconfig SnmptrapsetupSnmptrapserver SntpTftp SwtagvlanTime UpepUse Snmp CC100 Master Bridge User’s Guide Priority in Upstream and Downstream QoS802.1p TCP/UDP Port NumberSpecifications R M I N a L D E V I C E S E N D P O I N T A N M I S S I O N S P E E D a N D R a N G ELegal & Regulatory Information GNU General Public License Product Warranty Technical Support