Troubleshooting
Problem | Possible Cause | Solution |
|
|
|
No image appears on | Computer is not | Turn on computer. |
the screen | powered on. |
|
| Power cord is not | Tighten power cord connection and turn |
| securely connected. | on computer. |
| Video cable | Make sure the first display of a dual- |
| connected incorrectly. | headed system or the only display of a |
|
| |
|
| Video 1 port on the Dome DX2 display |
|
| controller. |
No display on console; | Switch 1 on DIP |
system does not boot. | switch S2 is set for |
| VGA mode. |
| Switch 2 on DIP |
| switch S2 is set to OFF. |
Disable VGA on all DX2 boards you install. Slide switch 1 on DIP switch S2 into the OFF position.
Check that EPROM is enabled on all Dome DX2 boards. Slide switch 2 on DIP switch S2 into the ON position.