Optoma Technology HDBV3080 Section II Installation of the Frame Components, Unpacking the Mirror

Installation Guide

HDBV3100, HDBV3090, HDBV3080

Section II: Installation of the Frame Components

1. Shipment of the Internal Frame Components to the Job Site

Once the outer master frame has been installed, have the remainder of the framing components available at the installation site. This includes the internal framing components and all electronics.

2. Unpacking the Mirror

Step 1:

Make certain that there are at least three people available for the unpacking and installation of the mirror. IMPORTANT! The mirror is heavy ~150lbs.

Step 2:

Remove the front of the crate by removing the screws with the red washers only.

Step 3:

Remove the two wood braces on the left and right side of the mirror that holds the mirror in the crate. The braces are held in place by two Philips screws on both sides of the mirror.

Step 4:

Carefully remove the mirror from the crate by lifting it slightly up and pulling it straight out.

Step 5:

Carefully set the mirror aside on a smooth surface.

See Figure 2-1: Exploded View of the Mirror and the Frame

For more information, please visit our website at:	Installation Guide
http://www.optomausa.com/BigVizion

19