Optoma Technology HDBV3080, HDBV3100, HDBV3090 manual FCC Warning

Page 4

Installation Guide

HDBV3100, HDBV3090, HDBV3080

FCC WARNING

This equipment has been tested and found to comply with the limits for a “Class B” digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception (this can be determined by turning the equipment off and on), the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna

Increase the separation between the equipment and the receiver

Connect the equipment to an outlet on a circuit that the receiver is not connected to

Consult the dealer or an experienced radio/TV technician for help

Any changes or modifications to this “Class B” digital device that has not been expressly approved by Optoma Technology, Inc. will void the user’s authority to operate the equipment.

TRADEMARK NOTICE

The BigVizionTM is a trademark of Optoma Technology, Inc. All other trademarks and registered trademarks are the property of their respective owners.

COPYRIGHT NOTICE

© Copyright 2006 Optoma Technology, Inc.

This document contains proprietary information protected by copyright. All rights are reserved. No part of this manual may be reproduced by any mechanical, electronic, or other means, in any form, without prior written permission of the manufacturer.

For more information, please visit our website at:

Installation Guide

http://www.optomausa.com/BigVizion

 



Image 4
Contents Installation Guide BigVizion In-Wall Rear Projection Display HDBV3100, HDBV3090, HDBV3080About this Manual FCC Warning Installation Preparation Mirror HandlingContents Section I Preparation for the Installation Position and Placement of the BigVizionPreparing the Wall Wall Preparation StepBigVizion Wall Opening Diagram. Figure 1100 BigVizion Wall Opening 290 BigVizion Wall Opening 380 BigVizion Wall Opening Shipment of Box 1 Master Outer Frame See -4 Box #1 Detail Step4Box #1 Detail Assembly of the Master Outer Frame 5Installation of the Master Frame Installation of the Master Outer Frame into the Wall Opening 6Installation of the Master Frame into the Wall Opening Shipment of the Internal Frame Components to the Job Site Section II Installation of the Frame ComponentsUnpacking the Mirror 1Exploded View of the Mirror and the Frame Installation of the Mirror 2Installation of the Mirror Assembly Step Locate Box 2. Refer to -3 The Unpacking Diagram Unpacking of Base Unit and ComponentsStep Refer back to Figure 3The Unpacking Diagram Box 2 Detail Assembly of the Base Unit Installation of the Projector Base StepInstallation of the Base Unit 5Installation of the Projector Base Installation of the Screen Frame See -6 Installation of the Screen 6Installation of the Screen Installation of the Wood Bezel 7Installation of the Wood Bezel Alignment Platform Adjustment Procedure Section III Alignment of the Light Engine1Setting the Gage on 0 Position 2Vertical Keystone Adjustment 3Horizontal Keystone Adjustment 4Skewed Image Adjustment 5Image Shift Vertically Adjustment 6Image Shift Horizontally Adjustment 7Image Sizing Adjustment Appendix a Cable Wiring/Connections CablesConnectors Connectors Instructions System Command Board Appendix B Discrete IR/RS-232C Codes HD3000 RS-232C Protocol Function ListFunction Description BasicOriginal Basic Update Appendix C Exploded View of the Product HDBV3100, HDBV3090, HDBV3080 USA