Advanced Configuration
NOTE! If you are using a wireless client when configuring WEP,
after pressing the Apply button you will not be able to have contact with the router until you have configured your wireless clients as
well. This is fully normal and is a proof that your network is now protected. Remember to enter the same keys at every device on the wireless network. Refer to your wireless client manual how to configure WEP as this will vary depending on what operating system and wireless client you are using.
9.6.3.2Association Control
The Configuration > WLAN > Association Control page allows you to enable the feature “ which is an effective and easy way to secure your wireless network from intruders. It doesn’t require any configuration of your computer(s) but on the other hand it doesn’t encrypt the traffic like WEP. This means that it is possible that someone could listen to your traffic, but they cannot access your computers, router or access the Internet.
Association Control will only stop people to use or communicate over your wireless network, i.e. they cannot access the HN294d, Internet or any or your WLAN computers, but they can with special programs listen to your wireless traffic. Your ordinary secure services like banking,
Enable Association Control
1.Enter the MAC address of the wireless client you want to allow access to the HN294d.
You will normally find the MAC address on the product label of your WLAN adapter. MAC addresses are given in the form
54 | EN/LZT 108 6377 R4 - September 2003 |