Garmin HN294DP/DI manual Parameter, Description, Dynamic Routing, Destination Address and Netmask

Advanced Configuration

1. Click the Create a new route button. The following page appears:

2.Enter parameters according to information in the table below and click the Apply button.

3.Select System > Save Configuration and click the Save button to save your new settings.

Description of parameters when creating a new Static Route:

Parameter

Destination Address and Netmask

Description

Identifies the destination IP address and netmask of the network where data packets are to be sent.

For default route enter 0.0.0.0 or leave the fields blank.

Forward packets to

Select Gateway Address and enter the IP address of the gateway on the LAN where data packets are to be sent. This is to be configured only when the LAN interface is configured as a route.

or

Select Interface and from the drop-down list select the ATM PVC interface where data packets are to be sent.

9.6.5.2Dynamic Routing

On the Configuration > IP Route > Dynamic Routing page you can enable/disable the Routing Information Protocol (RIP) that will help routers to determine optimal routes.

60 EN/LZT 108 6377 R4 - September 2003