InFocus 330 manual Connecting a Computer

Page 17

Connecting a Computer

1Plug one end of the VESA computer cable into the video con- nector on your computer.

2Plug the other end of the VESA computer cable into the connector on the projector.

audio cable

VESA cable

FIGURE 5

Connecting the projector to a computer

Do you want to play your computer’s audio on the projector?

1Plug either end of the audio cable into the audio connector on your computer.

2Plug the other end of the audio cable into the connector on the projector.

NOTE: Many laptop computers do not automatically turn on their external video port when a sec- ondary display device such as a projector is connected. Refer to your computer manual for the command that activates the exter- nal video port. Activation com- mands for some laptop computers are listed in the Appendix of this manual on page 38 and in the Service section of our website.

NOTE: If you are connecting an older Macintosh computer that does not have a 15-pin connector, you must use a Mac adaptor between the computer and the projector. See “Optional Accesso- ries” on page 37.

7

Image 17

Contents I D E Page Safety Certifications Declaration of Conformity Table of Contents Index AppendixSafety Instructions F e t y S t r u c t i o n s T R O D U C T I O N Introduction Image ResolutionCompatibility Unpacking the ProjectorT r o d u c t i o n Usage Guidelines If You Need Assistance WarrantySetting UP Projector Setting UP the Projector T t i n g O j e c t o r Connecting a Computer T t i n g O j e c t o r Audio Adapter Composite video cable Audio cable Connecting a Video PlayerCable Powering up the Projector and Adjusting the Image Turning Off the Projector Using Projector Using the Remote Control Using the ProjectorBasic Image Adjustment I n g O j e c t o r Adjusting the Projector Using the Keypad and Remote Buttons Standby Using the On-Screen Menus Display Menu Audio Menu Image Menu I n g O j e c t o r Position and Vert. Position Controls Menu Rear Projection Language Menu Status Menu I N T E N a N C E Troubleshooting Replacing the Projection Lamp Maintenance & TroubleshootingCleaning the Lens Pull the lamp door up and remove it Lift and grasp the pull tab and lift the module out Figure Using the Kensington Lock Replacing the Batteries in the Remote ControlProblem Color or text not being projected Troubleshooting Problem Nothing on projection screenProblem The screen resolution is not right Problem Image isn’t centered on the screenProblem Image is too wide or narrow for screen Problem Image and menus are reversed left to right Problem Image is out of focusProblem no sound Problem Image is noisy or streakedProblem Lamp shuts off Problem Lamp seems to be getting dimmerP E N D I Appendix SpecificationsStandard Accessories Ship with the projector Part Number AccessoriesOptional Accessories Key command to Computer Activate port De-activate port Portable and Laptop Activation ChartFN-F6 FN-F4 FN-F1 NCR Wyse Software driven Zenith FN-F10 Using Video Mirroring with a PowerBook Computer Feet Projected Image SizeD E Index D e Page Page Limited Warranty Part Number